Strobe-Master I
Safety instructions
Intended use
This device is intended to be used to control electronic strobe e ects devices. Any other use or use under other operating conditions is considered to be improper and may result in personal injury or property damage. No liability will be assumed for damages resulting from improper use.
Danger for children
Ensure that plastic bags, packaging, etc. are disposed of properly and are not within reach of babies and young children. Choking hazard! Ensure that children do not detach any small parts from the product. They could swallow the pieces and choke! Never let children unattended use electrical
devices.
Eye damage caused by high light intensity
To avoid eye damage caused by high light intensity, never look directly into the light source.
Quick Start Guide |
EN |
|
This quick start guide contains important information on the safe operation of the product. Read and follow the safety advices and instructions given. Retain the
manual for future reference. If you pass the product on to others please include this manual.
Where to use the product
Never use the product
•in conditions of extreme temperature or humidity
•in extremely dusty or dirty areas
•at locations where the unit can become wet
General handling
•To prevent damage, never use force when handling the product.
•Never immerse the product in water. Just wipe it with a clean dry cloth. Do not use liquid cleaners such as benzene, thinners or ammable cleaning agents.
Features
• For all DMX and analog strobes |
• Speed and brightness controllable via faders |
• Controller provides 10 programmes, Blackout, Single ash, Full on |
• Power supply unit included |
Operating
1. |
BLACKOUT |
- Blackouts the strobes (standby) |
|||
2. |
FULL ON |
- All strobes light up at once |
|||
3. |
SINGLE FLASH |
- All strobes will ash each time you press this button in |
|||
|
|
BLACKOUT mode |
|||
4. |
DIMMER |
- To adjust the brightness of DMX strobes in a range of |
|||
|
|
20 % to 100 % |
|||
5. |
SPEED |
- To adjust the chase speed in AUTO mode |
|||
6. |
MODE |
- Yellow LED indicates = AUTO mode |
|||
|
|
Green LED indicates = Sound-to-Light mode |
|||
7. |
CHASE |
- Press the |
buttons to select 10 chase patterns: |
||
|
|
0 |
= random patterns |
||
|
|
1 |
= 1234 (100 % brightness) |
||
|
|
2 = 1 2 3 4 4 3 2 1 |
|||
|
|
3 = 1 2 3 4 3 2 1 |
|||
|
|
4 |
= 12 34 24 13 23 14 |
||
|
|
5 |
= 1 12 123 1234 123 12 1 |
||
|
|
|
stop 4 43 432 4321 432 |
||
|
|
|
43 4 stop |
||
|
|
6 |
= 1 12 123 1234 234 34 4 |
||
|
|
|
stop 4 43 432 4321 321 |
||
|
|
|
21 1 stop |
||
|
|
7 = 1 3 2 4 3 1 4 2 |
|||
|
|
8 |
= 12 23 34 41 43 43 21 14 |
||
|
|
9 |
= 12 123 12 1234 |
||
8. |
POWER |
- Mains switch to turn the unit on / o |
|||
9. |
DC Input |
- Connect the supplied mains power adaptor here |
|||
CH1 CH4 |
- Outputs for analog strobes: |
||||
|
|
Signal: +12 V |
|
; 1/4” phone jack (mono) |
|
|
|
|
|||
DMX STROBE |
- DMX512 output for DMX strobes: |
||||
|
|
Channel 1: strobe rate, Channel 2: Brightness |
Technical speci cations
• Dimensions (W × H × D): |
210 mm × 133 mm × 77 mm |
||
• Weight: |
0.8 kg |
||
• Operating voltage: |
9 V |
|
/ 500 mA |
|
For the transport and protective packaging, environmentally friendly materials |
|
|
|
|
|
This product is subject to the European Waste Electrical and Electronic Equip- |
|
|
|
|
|
||
have been chosen that can be supplied to normal recycling. Ensure that plastic |
|
|
|
|
|
ment Directive (WEEE) in its currently valid version. Do not dispose of your old |
bags, packaging, etc. are properly disposed of. Do not just dispose of these ma- |
|
|
|
|
|
device with your normal household waste. Dispose of this product through an |
terials with your normal household waste, but make sure that they are collected |
|
|
|
|
|
approved waste disposal rm or through your local waste facility. Comply with |
|
|
|
|
|
||
|
|
|
|
|
||
for recycling. Please follow the notes and markings on the packaging. |
|
|
|
|
|
the rules and regulations that apply in your country. If in doubt, consult your |
|
|
|
|
|
|
local waste disposal facility. |
Thomann GmbH • Hans-Thomann-Straße 1 • 96138 Burgebrach • www.thomann.de • info@thomann.de |
DocID: 179734_26.11.2020 |