Think Tank Photo 017 User manual

Pixel Racing Harness V2.0 Instructions

ph: 866.55THINK (558.4465) fax: [phone]
3636 North Laughlin Road, Suite 170, Santa Rosa, CA 95403

Attachment to the FRONT of the belt

This is the correct harness position, as viewed from
the front. The harness can be adjusted in the front
and back after attachment to the belt. FOR STEROID

SPEED BELT: Attach clips around metal D-rings on belt.

Attachment to the BACK of the belt

This is the proper harness position, as viewed from the
back. The harness should be positioned 2 -3” below
the neck. FOR STEROID SPEED BELT: Attach rear clip
around metal D-ring on the back of the belt.

Step 1: The shoulder straps can be connected on the
belt anywhere towards the front of the body. Unclip the
buckle, then wrap it behind and under the belt. Insert
the female side of the buckle through the horizontal
webbing on the belt.

Step 1: Connect the rear harness strap in a similar
way as the front straps. To keep the harness properly
centered, insert the buckle through the webbing loop
with the Think Tank logo on it.

Step 2: Clip the buckle together to secure in place.
Then use the front buckles at the bottom of the
shoulder strap padding to adjust for proper length and
weight distribution.

Step 2: To adjust the length of the rear strap, use the
buckle located below the mesh. The rear buckle and
two similar front buckles are used to fine tune weight
distribution on the belt and harness.

For more information about this and other Think Tank products, visit www.thinktankphoto.com

The choice of working professionals