Thinkify TF6 User Manual

User manual – Installation Instructions

IDT T1000 TR 1000 Rail Reader

Thinkify

18450 Technology Drive
Morgan Hill, Ca. 95037

Product name: IDT T1000
Model Number: TR 1000

Legal Notice:

Copyright 2009 Thinkify LLC all rights reserved.
DOCUMENTATION IS PROVIDED “AS IS” AND ALL EXPRESSED OR IMPLIED
CONDITIONS,REPRESENTATIONS AND WARANTEES, INCLUDING ANY
IMPLIED WARRANTY, FITNESS FOR A PARTICULAR PURPOSE OR NON­INFRINGMENT ARE HEREBY ISCLAIMED, EXCEPT TO THE EXTENT THAT
SUCH DISCLAIMERS ARE HELD TO BE LEGALLY INVALID.

Professional Installation:

The IDT T1000 is a Part 90 LMS device. It is not available to the general public.
This product requires Professional Installation. Only professional installers are
allowed to set this unit up for its' intended use. The IDT T1000 is only available to
these professional installers. It is the responsibility of these installers to obtain a
site license from the FCC for Part 90 operation and install the interrogator in a
safe and secure manner consistent with the intent of the regulations.

Sole User:

IDT is the sole user authorized for use of this device for any and all rail
applications. Anyone using this device for rail applications must operate this
device under authorization and with agreement from IDT. IDT is trained in the
operation of installing part 90 devices and this device in particular. They are
professional contractors.
IDT has the responsibility of obtaining a site license for use to operate this reader
as a part 90 device.

FCC Compliance:

This equipment complies with Part 90 of the FCC Rules and Regulations. A site
license is required for each installation. It is the responsibility of the system
integrator/installer or user to obtain
the site license.

FCC Compliance (Digital Devices):

This equipment had been tested and found to comply with the limits of Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference with radio
communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which the user will be required to correct the
interference at his own expense.

Caution:

The IDT 1000D radiates energy. The RF emissions must be evaluated in
accordance with FCC OET Bulletin 56 “Hazards of radio frequency and
electromagnetic fields” and Bulletin 65 “Human exposure to radio frequency
electromagnetic fields” and appropriate precautions implemented.
All individuals working on or near the antenna should not be closer than
2 feet to the antenna when the RFID reader is operating into a 12 dBi antenna.
This is the minimum distance for human exposure recommended by FCC OET
Bulletin 56.