Thingverse 3DRC 2wd Buggy Assembly Manual
3DRC 2wd Buggy
Assembly Guide
Fin Hudson
Filament generously
provided by
Part Preperation
Key:
M3 - Drill hole to 2.5mm, then tap with an M3 tap
3mm - Drill hole to 3mm
2mm - Drill hole to 2mm
If a part is not listed here it requires no preparation
Quantities listed in red
Diff spider gear x3
Diff ring gear x1
2mm
3mm
Diff side gear x2
3mm
Diff box main x1 All holes M3
Rear suspension carrier x1
3mm
M3
M3
3mm
Diff box cover x1
3mm
M3
Diff box top cover x1
Part Preperation 2
Key:
M3 - Drill hole to 2.5mm, then tap with an M3 tap
3mm - Drill hole to 3mm
2mm - Drill hole to 2mm
If a part is not listed here it requires no preparation
Quantities listed in red
Motor guard x1
Countersink
on underside
Suspension carrier x3
3mm
3mm
M3
Rear arm lower LR x2
3mm
Rear arm upper LR x2
Rear hub (L x1& R x1)
3mm
M3
M3
Rear axle x2
3mm
M3
Rear shock tower x1
Dogbone LR x1
(metal inserts)
2mm
Front arm upper LR x2
Front main x1
All holes M3
Front shock
tower x1
M3 3mm
M3
Front arm lower LR x1
Part Preperation 3
Key:
M3 - Drill hole to 2.5mm, then tap with an M3 tap
3mm - Drill hole to 3mm
2mm - Drill hole to 2mm
If a part is not listed here it requires no preparation
Quantities listed in red
3mm
M3
Front hub L x1& R x1
Front knuckle L x1& R x1
All holes M3
Steering linkage L x1
M3
Steering linkage R x1
M3
3mm
3mm
Centre link x1
M3
3mm
Steering support x1
All holes M3
Steering link x2
All holes 3mm
Servo mount x1
All holes M3
8mm x 2mm shaft
22mm x 3mm shaft
RC car differential
shims (highly
recommended but
optional)
10x15x4mm bearing
x2
M3x12mm
10x15x4mm Bearing x2
M3x8mm
Loading...