Thetford 05223 User Manual

Installation Guide

Electra-Magic #05223 Vent Kit

1. Remove Cap and Splash Guard from
Electra-Magic Main Housing Cover on the
side desired for the Vent Kit instillation.

2. Determine where the Vent Fitting will be
located and drill a 3/4-inch hole through the
deck (hull) at that point. Note: Tube routing
should not create sharp bends or traps.

3. Insert Vent Fitting through hole and tighten
down nut securely.

4. Cut Tubing to proper length and put over
barbed end of Vent Fitting. Move Clamp into
place over the barbed area.

5. Screw Flange tightly into the Hose Barb.

6. Place Gasket and Flange into the hole pro­vided on the Electra Magic, noting locator pin
position, and screw securely into place.

7. Stretch Socket Filler over the hex body of
Hose Barb and work Socket Filler down

until it is ush with the top of Main Housing

Cover.

8. Put Tubing over Hose Barb and move Clamp
into place over the barbed area.

Thetford Corporation • P.O. Box 1285 • Ann Arbor, MI 48106

Form No. 05237 • Rev. 9/02