The Singing Machine classic STVG529BK, classic STVG529BW Instruction Manual

The Singing Machine® is a registered trademark or The Singing Machine Co., Inc.

STVG529BK/W

Instruction Manual

Please read before using this unit.

E - 1

Warnings

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT

R

EMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS

INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The Caution marking is located on the bottom panel.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

D

ANGEROUS VOLTAGE: The lightning flash with arrowhead symbol

within an equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the product’s
e

nclosure that may be of sufficient magnitude to constitute a risk of

electric shock to persons.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT AND FULLY INSERT.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE
T

HIS UNIT TO RAIN OR MOISTURE.

Class II equipment symbol.
This symbol indicates that the unit has a double insulation system.

A

TTENTION: The exclamation point within an equilateral triangle is

intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying
t

his product.

DANGER: This symbol is intended to alert the user to the risk of
exposure to invisible and hazardous laser radiation if the cover or back
i

s opened, the interlock fails or is defeated. Direct exposure to the

beam may damage your eyesight.

FCC WARNING: This equipment may generate or use radio frequency
e

nergy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
e

quipment if an unauthorized change or modification is made.
T

his device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

LASER SAFETY: This unit employs a laser. Only qualified service personnel
should attempt to service this device due to possible eye injury.
CAUTION: USE OF CONTROLS, ADJUSTMENTS OR PERFORMANCE
PROCEDURE HEREIN MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.

DRIPPING WARNING: This product shall not be exposed to dripping or splashing,
a

nd no objects filled with liquids, such as vases, shall be placed on the product.

VENTILATION WARNING: The normal ventilation of the product shall not be
impeded for intended use.
SAFETY VERIFICATION: This device is made and tested to meet safety standards
of the FCC, requirements and compliance with safety performance of the U.S.
Department of Health and Human Services and also with FDA Radiation
Performance Standards 21 CFR Subchapter.

NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
l

imits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
a

ccordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
i

nterference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

t

o which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• The rating information is located at the bottom of the unit.

Important Safety Information

1. Read these Instructions.

2. Keep these Instructions.

3. Heed all Warnings.

4. Follow all Instructions.

5. Do not use this apparatus near water.

6. Clean only with a dry cloth.

7. Do not block any of the ventilation openings. Install in accordance
with the Manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.

9. Do not defeat the safety purpose of the polarized or grounding­type plug. A polarized plug has two blades with one wider than the
other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your
safety. When the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus
combination to avoid injury from tip-over.

13. Unplug this apparatus during lightning storms
or when unused for long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such
as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been
dropped.

15. WARNING: To reduce the risk of fire or electric shock, do not expose
this apparatus to rain or moisture. Do not place objects filled with
water, such as a vase, on the apparatus.

16. The AC mains plug is used as the power disconnect device and it
should remain readily accessible and operable during intended use.
In order to completely disconnect the apparatus from power, the
main plug should be completely removed from the AC outlet socket.

17. CAUTION: To reduce the risk of fire or explosion, do not expose
batteries to excessive heat such as sunshine, fire or other heat
sources.

CAN ICES-3(B)/NMB-3(B)

CONTROL LOCATIONS

SKIP Bu tton
ON/OFF Button

ECHO Control
Monitor ON/OFF Button

PROGRAM Button

REPEAT Button

Monitor

CD Door

MIC Vol ume Con trol

MIC Hol der

ON/OFF Button

ON/OFF LED

A.V.C. Control

Speaker

PLAY/PA USE Button

BALANCE Control

MIC hol der

MASTER Volume

Control

MIC 2 J ack

MIC 1 J ack

AUX IN Jack

STOP Button

SKIP Button

BRIGHTN ESS Con trol
CONTRAS T Contr ol
VERTICA L HOLD
Control

DC Jack (12V)

AUDIO O UT Jack (L)

AUDIO O UT Jack (R)

VIDEO O UT Jack

FRONT VIEW

REAR VIEW

E - 2

E - 3

DISPLAY

PROG

PROG

00:16:04TRK 01/18CDG

P

PLLAAYYIINNGG TTII MMEE

-- RR EEPPEEAATT OO NNEE

-- RR EEPPEEAATT AA LL LL

-- NN OO RREE PPEEAATT FF UUNN CCTTIIOO NN

R

REEPPEEAATT MMOO DDEE

PPLL AAYY//PPAAUUSSEE//SSTT OOPP IINNDDIICCAATTOORR

-- PPLL AAYYIINN GG MMOODDEE

-- PPAAUU SS EE MMOODDEE

-- SSTTOOPP MMOODDEE

PPRR OO GGRRAAMM MM OODDEE

-- PPRR OO GG RRAAMM MMOO DDEE PPLL AAYYII NNGG

PPLL AAYYIINNGG TTRRAACCKK NNUUMMBB EERR AANNDD TT OO TTAALL TTRRAA CC KK NN UUMMBB EERR

-- CC DD PPLLAAYY II NN GG

PPLLAAYYIINNGG DDIISS CC MMOODD EE

-- CC DD GG PP LL AAYY II NN GG

CCDD GG

CCDD

1

A

CONNECTION

CONNECTING THE POWER

Insert the DC adapter into the DC jack. You can power the system from a standard AC outlet by using the
supplied Power Adapter (The adapter operates on AC 100V~240V /50Hz-60Hz).

CAUTIONS:

• The included AC adapter is for use with this unit only. Do not use it with other equipment.

• When the adapter is plugged in, the equipment is not completely disconnected from the main source of
power that runs from the outlet to the unit. This occurs even when the power button on the unit is placed
on the off position. Disconnect the power plug from the wall outlet to ensure that the equipment does
not receive any power source.