ThermoWorks Smoke Receiver Operating Instructions Manual

What’s Included:

Smoke Receiver, Batteries (Installed), neck lanyard, and this
instruction card.

How to Operate:

• To power Smoke Receiver on press the button.

• To activate backlight or mute an alarm press the button.

• To power Smoke Receiver off press and hold for 3
seconds.

How to sync:

• With Smoke Receiver powered off press and hold the power
button for 8 seconds until “SYNC” appears on the screen.

• Now that Smoke Receiver is in SYNC mode, make sure
Smoke is powered on.

• Press and hold the button for 6 seconds on Smoke.
The display should read “SYNC”.

• After pairing, Smoke Receiver should then display “END”

• Smoke will flash SYNC for a total of 10 seconds, then flash
END.

• At this time Smoke and Smoke Receiver are now paired

NOTE: To sync multiple Smoke Receivers, please follow the
steps above on one device at a time. Putting Smoke into Sync
mode will not disable or interfere with previously synced
receivers.

Go to www.thermoworks.com/smoke for additional product

information and more tips for use.

Smoke Receiver

Operating Instructions

This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.

Special Notice

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.

NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

P-13-025-02-a

www.thermoworks.com
741 E. Utah Valley Dr.
American Fork, UT 84003

For service or warranty:

1-800-393-6434
1-801-756-7705

[e-mail]

Smoke

VOL

SET

SET

ON

OFF

ON

OFF

2

1

°C/°F

CAL

ON

OFF

Smoke Receiver

PROBE 1

PROBE 2

Smoke Receiver

Blinks when transmission is received. Time to change batteries.

The Smoke Receiver display updates
every 15 seconds with live temperatures
from both channels. It will also show the
current Low/High temperature settings,
and if the alarm is on or off.

Transmission / Sync button

(Smoke)

Press to turn on Smoke Receiver.
Backlight comes on for 20 seconds.
Press and hold for 3 seconds to turn
Smoke Receiver off.