ThermoWorks 822-950 User Manual

Mini Temperature

Calibration Bath

Operating Instructions

Please read this Manual before using the product. Keep the manual handy for future
reference and ensure it is given to anyone who is to use the Bath.

Regular calibration (check) of a thermometer is essential to maintain confidence in your
readings. The Mini Temperature Calibration Bath provides a handy source of hot and cold
water.

Description

The Mini Temperature Calibration Bath is a simple, easy to use device to aid in the
comparison calibration of temperature probes. Water or oil may be placed in either the cup
provided or directly into the main well of the bath. Detailed instructions for use are given later
in the manual. Please observe the following safety instructions.

General Safety

We wish you to use the Calibration Bath as safely as possible – please follow these simple
precautions:

• Connect the bath to power by using either –

1. The main adapter to a 100-240 volt supply, or

2. The special cable for a cigarette lighter (12V supply).

• Do not pull the plug from the cigarette lighter by the cable.

• If any cable is damaged, it must be replaced to prevent possible electrical
hazards.

• Do not operate the bath if it is damaged.

• This bath should only be repaired by specialist personnel – return it to your
supplier.

• Pull out the plug from the power source when cleaning and after use.

• Ensure that the ventilation slots are not covered.

Operation Safety

• Before starting the bath ensure that the power supply cable and the plug are dry.

• Never start the bath with wet hands.

• Do not operate the bath on hot surfaces or near naked flames.

• Do not immerse the bath in water.

• Protect the bath and cable from heat and moisture.

• Do not allow water to enter the ventilation slots.

• The manufacturer cannot be held liable for damage resulting from improper use or
operation.

Connecting to a cigarette lighter

• Only use the bath when the vehicle is stationary.

• The ignition may need to be switched on to power the lighter socket.

Parts List

• 1 No. Mini Bath

• 1 No. Connection cable with mains adapter

• 1 No. Connection cable for cigarette lighter (12volt)

• 1 No. Calibration Cup

If any of the above parts are missing, please contact ThermoWorks.