ThermoWorks 810-960 User Manual

EcoTemp Thermometer 810-960

Instrument Operation

The instrument is switched on by pressing the ON/OFF button located on the front of the
instrument. Within one second the thermometer is ready to work. Apply the tip of the probe to
the substance or medium to be measured. The instrument reading may take a few seconds to
stabilize, depending on the nature of the measurement.

MAX /MIN Memory Function

Press the MA X/MIN button to display the maximum reading and a MA X symbol will ash in the
display. Press the MAX /MIN button again to display the minimum reading and a MIN symbol will
ash in the display. Press MAX /MIN button again to return to the normal reading. To clear the
MAX /MIN temperature memory, press the MAX/MIN and ON/OFF but tons simultaneously.

Alarm Function

To operate the audible alarm function, simply press the set button to adjust the high or low
alarm reading, the alarm settings will then ash in the display. The user can adjust the alarm
temperatures via the up or down key, pressing the set key to retain the information. The audible
alarm will sound when the temperature setting has been exceeded and will cease once the
temperatures have returned to within the boundaries set.

Battery Replacement

Replace the bat teries immediately if “Bat” illuminates or if the reading becomes erratic or the
display clarity fades, using two AAA, MN2400 or 1.5 volt equivalent. The bat teries are located
under the battery cover at the rear of the instrument.

EMC/RFI

Readings may be affected if the unit is operated within a radio frequency electromagnetic eld
strength of approximately 3 volts per metre, but the performance of the instrument will not be
permanently af fected.

EcoTemp Specications

Range -58 to +392°F (-50 to +200°C)

Resolution 0.1°C or 0.1°F

Accuracy ±1.8°F (-58 to +302°F) ±1°C (-50 to +150°C)

Battery AAA (2 x MN2400)

Battery Life 1,000 hours

Sensor Type Thermistor

Display Custom 22mm LCD

Dimensions 20 x 58 x 165mm

Weight 115 grams including probe

Product Warranty & Guarantee

This instrument carries a one-year warranty and guarantee against defects in either components
or workmanship. During this period, products that prove to be defective will, at the discretion of
ThermoWorks, be either repaired or replaced without charge.

The product warranty and guarantee does not cover damage caused by fair wear and tear,
abnormal storage conditions, incorrect use, accidental misuse, abuse, neglect, misapplication
or modication, or use with non-ThermoWorks hardware/software. No warranty of tness
for a particular purpose is offered and the user assumes the entire risk of using the product.
Any liability by ThermoWorks is limited only to the replacement of defective materials or
workmanship, and ThermoWorks accepts no responsibility for consequential loss. In line with
our policy of continuous development, we reserve the right to amend our product specication
without prior notice.

Ph: 801-756-7705 Fax: [phone]

Utah, USA

www.thermoworks.com