Thermo TECH SX-2145405, SX-2145407, SX-2145411, SX-2145415, SX-2145416 Installation Instructions

thermo

mirror heating element

VDE

tested

IPX4

Installation Instructions

thermo mirror heating elements

Model SX214XXX

• The mirror heating element has to be installed
by an authorised electrician, with the
DIN VDE 0100 taken into account.

• When used in bathrooms, the mirror
heating element has to be connected
to an ELCB (Earth Leakage Circuit Breaker)
with a release current of 30 mA.

• You must not bend, fold, cut, puncture
or perforate the mirror heating element.

• The back side of the mirror has to be
free of grease and dust.

• The protective film covering the adherend
has to be removed from the back of
the mirror heating element.

• The mirror heating element has to be attached
onto the clean back side of the mirror without blisters.

• Recommendation: connect the mirror heating element
to the light source of the mirror.

• Assemble the mirror into the mirror support

Warning notice according to EN 60335-1:2008

This device (mirror heating element) is not intended to be used by persons (including children) with limited physical,
sensory or mental ability or lack of experience and/or knowledge, unless supervised by an apt person responsible
for their safety, or unless they have received instructions as to how the device is used. Children have to be
supervised to ensure that they do not play with the device (mirror heating element).

Warning: If damage occurs to the connection cable or to the mirror heating element,

Note: It is not possible to carry out repairs, as the heating element has been welded and

thermo Flächenheizungs GmbH Phone [phone]
Robert-Bosch-Str. 7 Telefax [phone]
85296 Rohrbach E-Mail: [e-mail]
Germany Internet: www.thermo.de

the device (mirror heating element) has to be disconnected and disposed of.

the supply cable sealed.