Thermofilm ELEX eco 2400, ELEX eco 2000, ELEX eco 1500, ELEX eco 1000 User Manual

THERMOFILM AUSTRALIA 27 Rosalie Street, Springvale VIC 3171

Ph: 03 9562 3455 Fx: 03 9548 3979 www.thermofilm.com.au

ELEX

e

c

o

C O N V E C T I V E P A N E L H E A T E R S

ELEX eco CONVECTIVE PANEL HEATER

USER MANUAL

Models:

ELEX eco 2400
ELEX eco 2000
ELEX eco 1500
ELEX eco 1000

TABLE OF CONTENTS

1. Important Safety Instructions

2. Specification Data

3. Operating Instructions

3.1 Control Panel Guide

3.2 Switching on the Unit

3.3 Preset Temperature

3.4 Setting the 30min / 60min / 90min Timer

3.4.1 Setting the 30min Push Button Timer Programme

3.4.2 Setting the 60min Push Button Timer Programme

3.4.3 Setting the 90min Push Button Timer Programme

3.4.4 Changing to another Timer Setting in Mid Programme

3.5 Locking the Control Panel

3.6 Unlocking the Control Panel

3.7 Safety Notes

3.8 Maintenance

4. Installation Instructions

4.1 Installation Location

4.2 Wall Mounting Bracket

4.3 Castor Wheel Set

4.4 Electrical Connection

4.5 Safety Notes

5. Warranty

THERMOFILM AUSTRALIA 27 Rosalie Street, Springvale VIC 3171

Ph: 03 9562 3455 Fx: 03 9548 3979 www.thermofilm.com.au

ELEX

e

c

o

C O N V E C T I V E P A N E L H E A T E R S

1. Important Safety Instructions

• Prior to installing and operating the heater, read these instructions carefully and retain

for future reference.

• Indoor use only.

• Ensure the rated voltage is 230-240V.

• Do not install the heater directly below a socket.

• Always operate heater in an upright position with the control panel at the top. If using castor

wheel set, heater should be positioned on a flat horizontal surface.

• Arrange cord away from traffic areas so that it will not be tripped over.

• Do not place the cable under carpets /rugs.

• Do not remove plug from power socket by pulling the supply cord. Always grip plug.

• Do not operate this appliance if the cable or plug becomes damaged.

• In case of heater fault or damaged supply lead, the appliance should be returned to the

distributor / manufacturer for repair.

• Ensure the appliance is switched OFF before connecting to the mains power supply.

• Do not cover or restrict airflow to the inlet or outlet grills in any manner, as the appliance

may overheat and become a fire risk.

• Do not insert or allow foreign objects or metal utensils to enter any grill opening, as this may

cause an electric shock or fire damage to the appliance.

• Do not operate in areas where gasoline, paint or other flammable liquids are used or stored.

• Switch off the power supply and unplug from the mains socket when not in use, before

cleaning or changing accessories.

• To prevent overload and blown fuses, do not plug other appliances into the same power

outlet (receptacle).

• Do not immerse in liquid or allow liquid into the interior of the appliance, as this could create

an electric shock hazard.

• Do not reach for an appliance that has fallen into water. Switch off at supply and unplug

immediately.

• Do not operate appliance with wet hands. Always ensure that hands are dry before operating

or adjusting any switch on the product or touching the plug and mains supply connections.

• Never leave the appliance unattended when connected to the mains power supply.

• Do not cover. NEVER use the heater to dry clothes or similar articles.

• Do not position the appliances close to curtains or other combustible materials. Keep

combustible material such as furniture, cushions, bedding, paper, clothes, curtains etc. at least

1.0m away from the heater.

• The most common cause of overheating is deposits of dust or fluff in the appliance. Ensure

these deposits are removed regularly by unplugging the appliance and vacuum cleaning air
vents and grilles.

• This appliance heats up when in use. To avoid burns, do not let bare skin touch hot surface.

Switch off and let cool down before moving. Store the heater in a cool, dry location when not
in use.

• Do not use this appliance with a programmer, timer or any other devices that switches the

appliances on automatically.

• Do not use an extension cable with this appliance.

• Do not use the appliance in rooms less than 4m

2

area.

• This appliance is not intended for use by persons (including children) with reduced physical,

sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.

THERMOFILM AUSTRALIA 27 Rosalie Street, Springvale VIC 3171

Ph: 03 9562 3455 Fx: 03 9548 3979 www.thermofilm.com.au

ELEX

e

c

o

C O N V E C T I V E P A N E L H E A T E R S

2. Specification Data

Model

ELEX eco 1000 ELEX eco 1500 ELEX eco 2000 ELEX eco 2400

Power (W)

1000W

1500W

2000W

2400W

Voltage (V)

240V~50Hz

240V~50Hz

240V~50Hz

240V~50Hz

Dimension (mm)

420 x 440 x 105

580 x 440 x 105

740 x 440 x 105

1000 x 440 x 105

3. Operating Instructions

The control panel features a 30min / 60min / 90min push button timer with digital countdown timer
display. This heater is designed to heat at an economical preset temperature of 21°C for the chosen
time of 30min, 60min or 90min.

3.1 Control Panel Guide

1 - Main Power Switch (1/ 0 – ON / OFF)

2 - Unit Power button (ON / OFF)
3 - 30 minute push button timer
4 - 60 minute push button timer
5 - 90 minute push button timer
6 - LED screen

7 - Power On light

3.2 Switching on the Unit

Press the main power switch (1) on the right hand side of panel. Press the button (2) on the

control panel. This turns the unit ON, and the LCD screen (6) will illuminate displaying .

Note: The red “ON” indicator light (7) illuminates when the heating element is operating.

Upon first use, the heater may give off some fumes (this is normal).
Ensure that the room is ventilated (for example, open a window).

3.3 Preset Temperature

The preset temperature setting for the ELEX eco heater is 21°C, and this cannot be altered.

POWER