Thermasol 15-1006-XXX User Manual

15-1006-xxx

WALL MOUNTED BRASS SHOWER RAIL
WITH BOTTOM OUTLET INTEGRAL
WATERWAY - SQUARE

INSTALLATION INSTRUCTIONS

MOUNTING
SCREW

1"

1"

TILE ANCHOR

BRASS
INSERT

RAIL

TOOLS REQUIRED:

DRILL

•
1/4" MASONRY OR DIAMOND

•
TIPPED DRILL BIT
PHILLIPS HEAD SCREWDRIVER

•
BUBBLE LEVEL

•
MASKING TAPE

•
THREAD SEALANT TAPE

•
CAULK OR SILICONE SEALANT

•
PENCIL

•

USE THE INCLUDED ALLEN KEY TO

1.
REMOVE THE WATERWAY ELBOW
FROM THE BOTTOM OF THE RAIL
AND THE BRASS INSERT FROM
THE TOP.

PIPE NIPPLE
(NOT SUPPLIED)

WATERWAY
ELBOW

SET SCREW

WRAP THE THREADS OF THE PIPE

2.
NIPPLE WITH THREAD SEALANT
TAPE. THREAD THE PIPE NIPPLE
INTO THE SUPPLY PIPE.

SEAL THE GAP AROUND THE PIPE

3.
NIPPLE WITH SILICONE CAULK.

FAILURE TO SEAL THIS HOLE MAY
RESULT IN LEAKS AND WATER
DAMAGE.

SLIDE THE ESCUTCHEON OVER

4.
THE WATERWAY ELBOW.

THREAD THE WATERWAY ELBOW

5.
ON TO THE PIPE NIPPLE AND
TIGHTEN. MAKE SURE THAT THE
OUTLET OF THE WATERWAY
ELBOW ENDS UP POINTING
DOWNWARD.

SLIDE THE ROUND ANCHOR MOUNTED ON THE

6.
RAIL INTO THE HOLE IN THE FRONT OF THE
WATERWAY ELBOW. INSERT THE SET SCREW.

POSITION THE RAIL UPRIGHT AND USE A LEVEL

7.
TO ENSURE THAT IT IS VERTICAL. TIGHTEN THE
SET SCREW TO SECURE THE RAIL TO THE
WATERWAY ELBOW.

PUT MASKING TAPE ON THE WALL WHERE

8.
THE TOP OF THE RAIL WILL ATTACH.

CHECK THAT THE RAIL IS VERTICAL AND

9.
TRACE THE OUTLINE OF THE RAIL INTO THE
TAPE. REMOVE THE SET SCREW AND SET THE
RAIL DOWN.

PLACE THE RECTANGULAR BRASS INSERT

10.
AGAINST THE WALL, IN THE CENTER OF THE
OUTLINE FROM THE PREVIOUS STEP.

MARK THE CENTER OF THE HOLES.

11.

USING A 1/4" MASONRY OR DIAMOND

12.
TIPPED DRILL BIT, DRILL TWO HOLES, 1"
DEEP ON THE POINTS MARKED IN THE
PREVIOUS STEP. USE MEDIUM SPEED AND
STEADY PRESSURE. BE CAREFUL NOT TO
DRILL INTO EXISTING PIPES.

REMOVE THE TAPE. FILL THE

13.
HOLES WITH SILICONE SEALANT.

FAILURE TO SEAL THE HOLES MAY
RESULT IN WATER LEAKS.

INSERT THE INCLUDED TILE

14.
ANCHORS INTO THE HOLES. TAP
INTO PLACE CAREFULLY UNTIL
FLUSH WITH THE WALL.

MOUNT THE BRASS INSERT ON

15.
THE WALL USING THE INCLUDED
SCREWS. NOTE THE SMALL
DIMPLE ON ONE SIDE. THIS
DIMPLE WILL LINE UP WITH THE
SET SCREW TO HOLD THE RAIL.
ORIENT THE BRASS INSERT
ACCORDINGLY.

SLIDE THE ESCUTCHEON ON TO

16.
THE RAIL.

SLIDE THE RAIL ON TO THE BRASS

17.
INSERT AND TIGHTEN THE SET
SCREW. SLIDE THE ESCUTCHONS
SO THAT THEY ARE FLUSH WITH
THE WALL.

ATTACH THE HAND SHOWER HOSE

18.
TO THE WATERWAY ELBOW. USE
THE RUBBER SEALING WASHER IN
THE HOSE.