TECHNICAL
BULLETIN
Date: 06/4/2008
Product: CM 52 & CM 82 By:John Brasseur
Subject: -2 Cat number
Summary: Release of 460V 3 phase Unit configuration
This Tech bulletin is intended to inform the Thermadyne sales force that the Cutmaster True series 52 and 82 can now be ordered in a 460V
3 phase configuration. These units will ship with a 3 phase 460V cable with out a plug.
The catalog numbers are:
1-5130-2 Cutmaster 52 20ft hand
1-5131-2 Cutmaster 52 50ft hand
1-5132-2 Cutmaster 52 25ft mech
1-5133-2 Cutmaster 52 50ft mech
1-1130-2 Cutmaster 82 20ft hand
1-1131-2 Cutmaster 82 50ft hand
1-1132-2 Cutmaster 82 25ft mech
1-1133-2 Cutmaster 82 50ft mech
Additional information in combating Hypertherm and Miller regarding the issue of having to remove the cover when changing the phase
of the machine. This is a direct quote from Hypertherms PowerMax1250 Manual on page 3-5:
CAUTION: When using the standard model power supply (CE model is 3PH only) with a
single-phase power source, replace the supplied power cord with a 6 AWG
(16mm2) 3-wire power cord. The power cord must be connected by a licensed
electrician.
For More information Contact:
THERMAL DYNAMICS TECHNICAL SUPPORT
Phone: 1-800-752-7622
Fax: 1-603-298-7402
tdc-tech@thermadyne.com
www.thermadyne.com
Form 0002
West Lebanon, NH 03784
“Exceeding Customer Expectations Through Performance Excellence"
82 Benning Street
1-603-298-5711
Fax: 1-800-221-4401
TECHNICAL
BULLETIN
Date: 06/4/2008
Product: CM 52 & CM 82 By: John Brasseur
Subject: -2 Cat number
Summary: Release of 460V 3 phase Unit configuration
SETUP
Single Phase Power Cord (not for CE model)
CAUTION: When using the standard model power supply (CE model is 3PH only) with a
Power Cord Installation
Strip and prepare the power cord wires as
shown below:
Plug Installation
The plug should be connected to the power cord by a licensed electrician.
single-phase power source, replace the supplied power cord with a 6 AWG
(16mm2) 3-wire power cord. The power cord must be connected by a licensed
electrician.
7” (178 mm)
4” (102 mm)
L1
L2
Ground
#10
L1 & L2
Power Switch
Ground
Route lead
through
strain relief
and tighten.
powermax1250 Operator Manual 3-5
For More information Contact:
THERMAL DYNAMICS TECHNICAL SUPPORT
Phone: 1-800-752-7622
Fax: 1-603-298-7402
tdc-tech@thermadyne.com
www.thermadyne.com
Form 0002
0
82 Benning Street
West Lebanon, NH 03784
1-603-298-5711
Fax: 1-800-221-4401
“Exceeding Customer Expectations Through Performance Excellence"
Loading...