THERMAL DYNAMICS All Cutmaster True (Except CM 39 and CM 10) Troubleshooting instruction

TECHNICAL

BULLETIN

Date: 02/9/2010
Product: All Cutmaster TRUE (except CM 39 and CM 10)
Subject: Standoffs soldering joints
Summary: Inspection and Rework if applicable

Valued Thermadyne Service Provider,
It has come to our attention that a small batch of Main PCBoards on the Cutmaster units may have a problem

with the soldering on the Standoffs. Even though most of the boards were caught in house we feel is important to
make you aware of this situation and perform a simple inspection when you happen to receive a Cutmaster unit
in you shop:

9 Review date code of the Main PCBoard (see the picture below).
9 If the Main PCB has the code 11/09 replace.

Note: The previous procedure only applies for boards with date code 11/09

boards with a different date code.

Please do not hesitate to contact us if you have any questions

THERMAL DYNAMICS TECHNICAL SUPPORT

Phone: [phone]
Fax: [phone]
[e-mail]

www.thermadyne.com

Form 0020

“Exceeding Customer Expectations Through Performance Excellence"

. There is no need to replace the Main

82 Benning Street

West Lebanon, NH 03784

1-603-298-5711

Fax: [phone]