Thermador PA60RLBG Installation

60'' Backguard and Toe Kick
Installation Instructions

PA60RLBG Backguard
Installation

WARNING
State of California Proposition 65 Warnings:

This product contains chemicals known to the State of
California to cause cancer, birth defects or other
reproductive harm.

WARNING

Fingers or hands could get pinched when installing the
backguard. Severe injury could result. Use extreme
caution and wear thick protective gloves to avoid potential
laceration to finger or hand while sliding the backguard
down onto the range.

1. Remove the T-20 Torx stainless screws in the front
face of the included Flush Island Trim.

WARNING

To reduce the risk of fire or injury to persons, check to
make sure all packaging has been removed from
accessory devices before use.

Tools Needed

T-20 Torx head screwdriver or drill

Protective Work Gloves

2. Remove the drill point screws securing the piece to the
back panel. Lift up to fully remove.

English | 1 |

3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. Make sure the backguard’s front face is
outside the flange on the front side of the range.

4. Reinstall screws removed in Steps 1 and 2.

2. Remove the leg covers by sliding the top, outer sleeve
of the leg covers off the extruded dimples of the base.

Installing the Toe Kick Panel

3. Remove protective plastic covering from the Toe Kick
Panel.

4. Beneath the range, with the holes and flange facing up,
wrap the Toe Kick Panel around the base.

Toe Kick Panel

Tools Needed

T-20 Torx head screwdriver or drill

Protective work gloves

Remove the Front Foot Cover Assemblies

1. Remove the (2) T-20 Torx head screws securing the
foot cover assembly to the range base, as shown in the
figure below. Repeat for the other front foot cover
assembly.

5. The mating part has extruded dimples on both sides for
which the holes of the Toe Kick Panel should seize.
You should feel a definitive snap, letting you know that
the part has been installed.

6. Mount the Toe Kick Panel on both sides of the unit into
the extruded dimples using the (4) T-20 Torx drill point
screws provided.

English | 2 |