Thermador PA36JLBG Installation

Backguard and Toe Kick Installation Instructions

Backguard Installation

Model Low Back Flush Island Trim

36'' PA36JLBG Included on Range

48'' PA48JLBG Included on Range

48'' Steam PA48JLBSG Included on Range

When using the Flush Island Trim, THERMADOR recommends a minimum 12'' (305 mm) rear clearance to a combustible surface. Clearances from non-combustible materials are not part of the ANSI Z21.1 scope and are not certified by CSA. Clearances of less than 12'' (305 mm) must be approved by the local codes and/or by the local

authority having jurisdiction.

WARNING

State of California Proposition 65 Warnings:

This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.

Removing the Flush Island Trim

1. Depending on model, remove the (3) or (4) T-20 Torx stainless screws in the front face of the included Flush

Island Trim.

2. Remove the (4) drill point screws securing the trim to the side panels, and the (2) to (4) drill point screws securing the piece to the back panel. Lift up to fully

remove.

WARNING

Fingers or hands could get pinched when installing the backguard. Severe injury could result. Use extreme caution and wear thick protective gloves to avoid potential laceration to finger or hand while sliding the backguard down onto the range.

Low Back Parts Included

1 – Low Back panel

8 or 9 – T-20 Torx stainless screws 8 or 6 – T-20 Torx drill point screws

Tools Needed

T-20 Torx head screwdriver or drill Protective Work Gloves

English 1 9001078742 • Rev. A • 5U06U8 • © BSH Home Appliances Corporation, 05/15

Installing the Lowback

Remove the Front Foot Cover Assemblies

3. Align the back panel of the new accessory with the flanges on the range side panels right and left rear corners. The backguard is inserted inside the guide channels on the back of the range.

1. Remove the (2) T-20 Torx head screws securing the foot cover assembly to the range base, as shown in the figure below. Repeat for the other front foot cover

assembly

2. Remove the leg covers by sliding the top, outer sleeve of the leg covers off the extruded dimples of the base.

4. Make sure the backguard’s front face is outside the flange on the front side of the range.

5. Re-install screws removed in Steps 1 and 2.

Toe Kick Panel (PA [36,48] JTKG)

Toe Kick Parts Included

1 – Toe Kick Panel

4 – T-20 Torx drill point screws

Tools Needed

T-20 Torx head screwdriver or drill

Protective work gloves

Installing the Toe Kick Panel

3. Remove protective plastic covering from the Toe Kick Panel.

4. Beneath the range, with the holes and flange facing up, wrap the Toe Kick Panel around the base.

5. The mating part has extruded dimples on both sides for which the holes of the Toe Kick Panel should seize. You should feel a definitive snap, letting you know that the part has been installed.

6. Mount the Toe Kick Panel on both sides of the unit into the extruded dimples using the (4) T-20 Torx drill point screws provided.

+ 4 hidden pages