Thermador PA36GLBH BACKGUARD INSTALLATION INSTRUCTIONS
WARNING
:
WARNING:
• The backguard must be attached before sliding the range into its final,
installed position. A Low Back or Pot-and-Pan Shelf must be installed when
there is less than 12” clearance from a combustible back wall and the back
of the range above the cooking surface. SEE RANGE INSTALLATION
MANUAL.
• A Flush Island Trim is available for covering the back area of the range for
island installations; however, the Flush Island Trim can only be used where
there is a minimum of 12” horizontal clearance between a combustible back
wall and the back of the range.
• Remove the griddle plate for sufficient installation clearance, on models with
griddle. The backguard is inserted inside the guide channels on the back of
the range, as shown in the illustration.
concerning potential injury!
backguard with four (4) of the included Torx-head screws to the range’s side
panels, two (2) screws to the range’s back panel, and four (4) screws to the
area around the cooling blower.
• To secure the front of the backguard, install three (3) of the Torx-head
screws through the lower front panel of the backguard, into the flange at the
back of the range’s cooktop.
• The Pot-and-Pan Shelf requires pre-assembly of the top panel to the shell
using nine (9) of the enclosed Torx-head screws. For sufficient load
strength, YOU MUST attach the two (2) screws through the back corners of
the top down into the shell.
• The Pot-and-Pan Shelf provides a shelf above the cooktop to keep foods hot
or store cooking pans.
hot! DO NOT place any of the following
items on top of the Pot and Pan Shelf:
• “plastics” or containers that can melt.
• flammable items.
• a total load over 30 pounds (13.6 kg).
BACKGUARD INSTALLATION INSTRUCTIONS – PRO-HARMONY™ GAS RANGES
Pay attention to the WARNING
Using a T-20 size Torx driver, fasten the
OBSERVE CAUTIONS BELOW.
CAUTION:
The Pot and Pan Shelf can get very
Front of Range
The back panel of backguard is positioned inside these two
guide channels on the back of the range.
Fingers or hand could get pinched
when installing the backguard. Severe injury could
result.
Use extreme caution and wear thick protective gloves
To avoid possible burn or fire hazard, a backguard designed
specifically for this range must be installed whenever the range is used.
5551 McFadden Avenue, Huntington Beach, CA 92649 • 800-735-4328 • www.thermador.com
9000476120 • 5U02Z5 • Rev. B • 1/10 • © BSH Home Appliances Corporation, 2009 • All rights reserved
to avoid potential cut or laceration to fingers or hand
while sliding the backguard down onto the range.
Litho in USA
Loading...