Thermador CIT365KM Installation manual
COOKTOPS
ct
the
s s
pec
pec
ic
fonea
rby
rby
rby
rby
rby
cocmstisble
ble
e
toto
o
o
wiwiwitha minimumu
bobothhsid
e w
e weall
all
s a
s as anth
aan addidddtioonal
naln1"1"lceaeaearanc
ty
ty
ty
ty
ty
so
s
s,
s,
theheeat athiss
eld
is
i
pr
pre
e
pre
pre
e
e
vevtsssscomcc
po
po
ent
tets ss
o
f therre
irc
irc
ircutioiotio
tioof
f
NSTSTAATITIONONABEVEAAATTTHHERMRMMADAD
36-INCH INDUCTION
CIT365KB / CIT365KM / CIT365KBB
COOKTOPS — INDUCTION
INSTALLATION OPTIONS
INSTALLATION ABOVE A BUILT-IN OVEN OR
WARMING DRAWER
Thermador Induction Cooktops may be installed above
a Thermador Single Built-in Oven. A minimum 1" air
gap must be maintained between the bottom of the
cooktop and the top of the oven.
Thermador Cooktops may also be installed above a
Thermador Warming Drawer to create a convenient
cooking center. Refer to the warming drawer section
for additional specications.
IMPORTANT
We strongly recommend the installation of a Thermador
Ventilation System with this induction cooktop.
Seal the surfaces of the cutout to make them heat
resistant. This prevents the surfaces from expanding
as a result of humidity.
Solid surface countertops often require special
installation. For example, heat reective tape or
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specic
to your countertop.
WARNING
To reduce the risk of ignition of nearby combustible
materials, install the countertop with a minimum
distance of 2" (51 mm) from both side walls and the
back wall.
at reective tape or
cessary. Conta
r instruction
36-INCH COOKTOP AND CUTOUT DIMENSIONS
NOTE: The work surface should be
horizontal and level. The stability of
the countertop should be conrmed
even after making the cutout.
HEAT SHIELD
The heat shield will require an additional 1" clearance
below the cooktop. For safety reasons, the heat shield
must be properly installed. This prevents components
from overheating as a result of the recirculation of
hot air from the cooktop. The heat shield is the same
width as the cooktop. For shipping, it is screwed to the
burner box. Once installed, the heat shield will be able
to rotate freely, as shown in the illustration. Refer to the
instructions packed with product for installation details.
e
heat shield
INSTALLATION ABOVE A THERMADOR BUILT-IN OVEN
1.800.735.4328 | THERMADOR.COM 103
Loading...