Thermador CIT151DS User Manual

Specifications and Main Features

  • Manufacturing brand: CIT151DS
  • A 20 Amperes circuit breaker is provided.
  • 240 Volts and 3 wires with 60 Hertz frequency.
  • 208 Volts and 3 wires with 60 Hertz frequency.
  • Appliance height: 85mm (3 1/3 inches)
  • Full height with fitted heat shield: 135mm (5 1/3 inches)
  • Incorporates one meter of flexible conduit for wiring purposes.
  • Frontal heat shield is as wide as the cook top.
  • Two sidewards heat shields are provided free.
  • Hold down brackets are provided to facilitate installation.
  • Maximum distance from the cooktop surface to the underside of cabinets is thirty inches (762 millimeters) or twenty four inches (610 millimeters) with adequate protection.
  • To protect against overheating of components, a heat shield has to be fitted.
  • Junction Outlet must not be more that 3ft away from the cooktop connection.

Frequently Asked Questions

Q: Do you know what type of breaker is required for the CIT151DS model of the cooker or what is the circuit breaker rating?

A: The model requirements a circuit breaker rating of either 20 Amps for 240 Volt and 208 Volt.

Q: Can you tell me what the dimension of the cooktop in CIT151DS model is?

A: The unit has an 85 mm height or 3 1/3 inches which makes it 135 mm or 5 1/3 inches with the heat shield installed.

Q: Do heat shields have to be installed?

A: Indeed, it is imperative to install heat shields to avert the chances of overheating and allowing the warm air around the cooktop to cool down and circulate.

Q: How much space would be needed from the cooktop to the cabinets or any other load-bearing shelves above it?

A: In an ideal setting, a safe distance of not less than 30” (762mm) should be maintained, although this can be brought down 24” (610mm) if substantial flame-retardant shielding is properly installed and located.

Q: What tools are needed to install the cooktop?

A: A range of tools is required to perform the installation including but not limited to a jigsaw, tape measure, drill with a quarter inch bit and a Philips head screwdriver.

User Manual

Page 1
Thermador CIT151DS User Manual
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7
Page 8
Page 9
Page 10
Page 11
Page 12
Page 13
Page 14
Page 15
Page 16
Page 17
Page 18
Page 19
Page 20
Page 21
Page 22
Page 23
Page 24
Page 25
Page 26
Loading...