Thermaco W-200-IS-230-SS User Manual
Big Dipper® IS Point Source Automatic
1
2
28.50 in
723.9 mm
17.85 in
453.4 mm
2.375 in
60.3 mm
14.55 in
369.6 mm
6.00 in
152.4 mm
25.50 in
647.7 mm
INLET
OUTLET
GC-50000
GREASE COLLECTOR
7 QUART (6.6 L)
CAPACITY
24.25" (616 mm) CLEARANCE
FROM BOTTOM OF TANK
REQUIRED FOR STRAINER
BASKET & LID REMOVAL
1
2
3
4
28.50 in
723.9 mm
17.85 in
453.4 mm
2.375 in
60.3 mm
14.55 in
369.6 mm
6.00 in
152.4 mm
25.50 in
24.57 in
624.0 mm
1.75 in
44.5 mm
8.80 in
223.5 mm
2.00 in
50.8 mm
VESSEL VENT WITH
1" NPT CONNECTION
2" (50mm) PIPE
INLET/OUTLET
INLET
OUTLET
GC-50000
GREASE COLLECTOR
7 QUART (6.6 L)
CAPACITY
24.25" (616 mm) CLEARANCE
FROM BOTTOM OF TANK
REQUIRED FOR STRAINER
BASKET & LID REMOVAL
1
2
Grease Removal Systems
W-200-IS-SS Specications
PRODUCT FEATURES
Fully automatic self cleaning cycle. Removes
collected grease & oils from tank without any
operator assistance. Comes complete with Digital
Control and Grease Collector.
Constructed of corrosion resistant materials suitable
for installation in virtually any location. Attractive
sanitary Stainless Steel exterior.
Integrated Motor/Grease Outlet/Heater/Lid enables
a fast, do-it-yourself unit operation reversal.
Compact footprint.
Two (2) No-Hub Connectors provided.
Vessel Vent Connection with 1” NPT Connection for
easy installation.
Conforms to ASME Standard
ASME A112.14.3 and A112.14.4
SPECIFICATIONS
Construction: Exterior: 304 Stainless Steel, Bright Finish
Interior: Rotationally Molded Polyethylene
Electrical: 115 VAC, 50/60 Hz, 520 Watts (4.5 Amps)*
Flow Rating: 20 GPM (1.26 l/s)
No. of Skimming Wheels: 1
Skimning Rate: 20 Pounds (9.08 Kg) Per Hour
Grease Capacity: 47.1 Pounds (21.4 Kg)
Solids Strainer Capacity: 1.85 Gallons (7 Liters)
Inlet/Outlet: 2” (50 mm)
*For Additional Electrical Congurations, see Electrical Variations section on page 2.
®
®
24.25” (616 mm) CLEARANCE
REQUIRED FOR STRAINER
FROM BOTTOM OF TANK
BASKET & LID REMOVAL
Thermaco, Inc. • PO Box 2548 • Asheboro, NC 27204-2548 • (336) 629-4651 • www.big-dipper.com
3/16
©2016 Thermaco, Inc. • All rights reserved • Patented/Patents Pending • Specications subject to change without notice
END VIEW
SIDE VIEW
28.50 in
723.9 mm
TOP VIEW
2.375 in
60.3 mm
17.85 in
453.4 mm
1
Big Dipper® IS Point Source Automatic
1
2
3
17.85 in
453.4 mm
4.00 in
101.6 mm
6.69 in
169.8 mm
4.00 in
101.6 mm
6.00 in
152.4 mm
6.00 in
152.4 mm
OUTLET
GC-50000
GREASE COLLECTOR
INLET
Grease Removal Systems
W-200-IS-SS Specications
INSTALLATION NOTES
1. READ instruction manual included with system before
installing/operating.
2. Install unit allowing for the minimum clearances
shown. Make sure there is sufcient space above Internal
Strainer access cover to remove the strainer [minimum
of 14” (356mm)]
3. Make piping connections with rubber “No Hub” connectors.
4. Keep outlet piping as straight as possible. Use only
“sweep” connections.
5. Install vent on outlet piping.
6. Fill the tank with water before energizing the power
to the motor and heater.
7. Do not install “P” Trap on outlet connection of tank
(unit already has internal gas trap).
8. Do not reduce pipe size on outlet piping
9. Do not pressure test unit.
Equipment must be installed in compliance with all applicable laws, regulations and codes, including plumbing
codes. Installation should be performed by a qualied
plumbing contractor.
JOB SPECIFICATION
Grease and oils separator(s) shall be Thermaco Big Dipper automatic grease/oil recovery system(s) as manufactured by Thermaco, Inc., Asheboro, North Carolina as noted on plans.
AUTOMATIC GREASE REMOVAL DEVICE SPECIFICATIONS
Furnish and install ___ Thermaco Big Dipper Model No. W-200-IS-SS, bright nish type 304 stainless steel exterior, rotationally
molded polyethylene interior automatic self-cleaning grease and oil recovery separator(s) for oor mounted or partially recessed
installation, rated at 20 gallons per minute (1.26 liters per second) peak ow, 47.1 pounds (21.4 Kg) of grease capacity and in-
cluding as an integral part of the unit, 1 rotating gear hydrophobic wheel assembly for automatic grease/oil removal, an integral
ow control device, self-regulating enclosed electric immersion heater, a vessel vent, an integral gas trap, a digital control for
programmable operation, a eld reversible motor location, a eld reversible grease/oil sump outlet, quick release stainless steel
lid clamps, a gasketted and fully removable 304 stainless steel lid, a lift-out strainer basket access, an internal stainless steel
strainer basket for collection of coarse solids, and a separate grease and oils collection container. Electric assembly shall be
tested to comply with pertinent sections of the Standards for Safety ANSI/UL 73 and/or ANSI/UL 1004. Electric motor equipped
with overload protection. Two (2) no-hub connectors for plumbing connection provided.
ELECTRICAL VARIATIONS
W-200-IS-SS: 115V 50/60Hz, 520 Watts (4.5 Amps)
W-200-IS-230-SS: 230V 50/60Hz, 520 Watts (2.3 Amps)
SUBMITTAL OPTIONS
FS-1 Point Source Flat Strainer
ESU-1 External Strainer (1.16 Gallons of additional solids storage capacity)
AP-6000-1-TK Alarm Probe for excessive grease accumulation
AP-6000-1-TKDC Alarm Probe with dry contact for remote warning light notication
HAG-2 Horizontal Air Gap Assembly with 2” connection
HAG-BA-1 Solids Strainer Baskets for use with HAG-2 Assembly (Specify Quantity based on Number of Sinks: ___)
3/16
©2016 Thermaco, Inc. • All rights reserved • Patented/Patents Pending • Specications subject to change without notice
Thermaco, Inc. • PO Box 2548 • Asheboro, NC 27204-2548 • (336) 629-4651 • www.big-dippper.com
2
Loading...