THERMACELL® MOSQUITO
REPELLENT APPLIANCES
1. Remove one mat from wrapper.
2. With device off and completely cool, insert mat
under grill.
3. Remove appliance cover and butane cartridge
cap. Screw cartridge into receptacle and
replace appliance cover.
4. Turn switch to ‘ON’, wait 5 to 10 seconds then
depress start button 3 to 5 times in rapid
succession.
5. Verify appliance is heating; orange light will
glow. If the light is not glowing, make sure
cartridge is completely screwed into place;
then repeat step 4. Place on a flat, stable area.
6. When finished using, turn switch to ‘OFF’.
7. Allow to completely cool and then store.
1. Remove one mat from wrapper.
2. With device off and completely cool, insert mat
under grill.
3. Remove Patio lantern top and butane cartridge
cap. Screw cartridge into receptacle and
replace Patio lantern top.
4. Move switch to ‘ON’, wait 5 to 10 seconds then
depress start button 3 to 5 times in rapid
succession.
5. Verify Patio lantern is heating; orange light will
glow. If the light is not glowing, make sure
cartridge is completely screwed into place;
then repeat step 4. Place on a flat, stable area.
6. When finished using, turn switch to ‘OFF’.
7. Allow to completely cool and then store.
1. Remove one mat from wrapper.
2. With device off and completely cool, insert mat
under grill.
3. Remove Outdoor lantern top and butane
cartridge cap. Screw cartridge into receptacle
and replace Outdoor lantern top.
4. Move switch to ‘ON’, wait 5 to 10 seconds then
depress start button 3 to 5 times in rapid
succession.
5. Verify Outdoor lantern is heating; orange light
will glow. If the light is not glowing, make sure
cartridge is completely screwed into place;
then repeat step 4. Place on a flat, stable area.
6. When finished using, turn switch to ‘OFF’.
7. Allow to completely cool and then store.
THERMACELL® MOSQUITO
REPELLENT PATIO LANTERN
THERMACELL® MOSQUITO
REPELLENT OUTDOOR LANTERNS
THERMACELL
®
MOSQUITO
REPELLENT LANTERNS & TORCH
1. Remove one mat from wrapper.
2. With lantern off and completely cool, insert mat
under grill.
3. Remove butane cartridge cap and screw into
lantern base opening. Place lantern on a flat,
stable area.
4. Rotate lantern collar to the right until the
indicator line points to “ON”, wait 5 to 10
seconds then rotate lantern collar further to the
right until the indicator line points to “START”.
Repeat 3 to 5 times in rapid succession.
5. Verify lantern is operating; lantern will glow. If
the lantern is not glowing, make sure cartridge
is completely screwed into place; then repeat
step 4. For full size lantern, orange light will
glow in view hole located on the lantern lid.
6. When finished using lantern, rotate lantern
collar
to the left until the indicator line points to “OFF”.
7. Allow lantern to completely cool and then store.
Torch: Replace protective cover; leave outside
or store.
Manufactured for: ©Thermacell Repellents, Inc.
26 Crosby Dr, Bedford, MA 01730
Email: consumerquestions@thermacell.net
Toll Free: 1-8-NO-SKEETER
Thermacell® is a Registered Trademark of
Thermacell Repellents, Inc.
ab0915