ThermaCell Heated Insoles Operating Instructions Manual
ThermaCELL®HeatedInsoles
WelcometoThermaCELL
Dear ThermaCELL® Heated Insoles Purchaser:
We are pleased that you made the decision to purchase ThermaCELL
Heated Insoles, featuring wireless remote control and rechargeable
embedded Lithium-Ion Polymer batteries. Your purchase features
patented rechargeable Heated I nsoles with Remote Control ON/ OFF
heat operation.
The ThermaCELL self-contained advanced heat technology is great
for cold weather activities. The technology enables purchasers to
remotely control temperature adjustments while wearing shoes or
boots. Operating Instructions included within this document provide
clear and concise directions on how to set up your Insoles for remote
control temperature operation.
®
Technology
ThermaCELL products, including the ThermaCELL mosquito repellant
product line, have enabled outdoor enthusiasts to enjoy their
activities (hunting, fishing, camping, etc) with confidence and in
comfort. We thank you for your purchase of ThermaCELL Heated
Insoles an d are co nf id en t that , as a r es ult , yo ur co ld w ea th er act i vi t ies
will be more comfortable and enjoyable.
Enjoy your purchase.
The ThermaCELL Product Group
Page 1 of 4 (05/26/10)
ThermaCELL®HeatedInsoles
OperatingInstructions
PACKAGE CONTENTS
The ThermaCELL® Heated Insoles box contains two Heated Insoles, one Remote Control Unit,
one Global Charger, and one Drawstring Travel Bag.
GETTING STARTED
The ThermaCELL Heated Insoles must be fully charged until the LED light on the Global
Charger turns from Red to Green. This may take up to 6 hours for the first charge.
Subsequent charges will take about 3 hours. The ON/OFF Switch and Recharge Port, located
at the back of both insoles (in the heel area), are protected by a soft plastic black cap.
CHARGING
IMPORTANT: both Insoles must be charged at the same time while following these steps:
1. Set the ON/OFF Switch on each Insole to the left position (“OFF”).
2. Plug the Global Charger into the wall receptacle. The LED light on the Global
Charger will glow Green.
3. Plug in Global Charge r cables into each Insole Recharge Port, which can be found at
the heel of the Insole. The LED ligh t on the Global Charger will turn Red once
connections have been established.
4. After charging is complete, the LED light on the Global Charger will turn Green.
5. Unplug the Global Charger and remove the cables from both Insoles. The
ThermaCELL Heated Insoles are now ready to be used.
TO ACTIVATE THE INSOLES
1. Turn each heated Insole on by moving the ON/OFF Switch at the heel of the Insole to the
right position (“ON”).
2. Unpack the Remote Control unit and remove the protective tab to enable the already
installed replaceable battery to activate.
3. Press and immediately release the black button on the Remote Control unit. The left LED
light on the Remote Control unit will flash Red several times to indicate that the Insoles are
now in Standby mode.
4. Press the black button again within 4 seconds and release to cycle through the existing
temperature settings (Standby – Medium 100°F – High 111°F).
a. The LED light on the Remote Control unit will flash several times after being activated:
Standby – left light Red
Medium – center light Green
High – right light Green
5. The Red LED lights at the heel of the Insoles will blink continuously as follows:
Standby - one blink
Page 2 of 4 (05/26/10)
Loading...