The Galley IWS-5-S-BA, IWS-5-S-GT, IWS-5-S-GR, IWS-5-S-WH Installation Guide
Ideal Workstations™, Workstations with DryDock™,
BarStations
and WashStations™ Installation Guide
®
18” Finished cutout
1/2” Reveal front
and back
16”
Side view applies to all
Single Bowl Workstations
Single Bowl Workstations
10”
IWS 7S
IWS 2C*
IWA 30S
IWS 6S
IWS 5S
IWS 3S
SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE
(Recommendations are based on installing 3 or more Tap accessories)
Galley Tap 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Galley Deck Switch 1 3/8" min hole diameter or Galley Automatic Strainer Basket knob 1" min and 1 3/8" max hole diameter
Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Galley Soap Dispenser 1" min hole diameter
Center hole diameters 2" behind cutout
Note: Galley Hot and Cold Water dispenser requires a minimum 8" clearance center to center if installed to the right of the Galley Tap
1
1
2
2
2
3
3 4
*IWS 2C SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE
Galley Deck Switch 1 3/8" min hole diameter or Galley Soap Dispenser 1" min hole diameter
Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
1
IWS 4S
1 2
2
Note: For installation where the drain is on the left side, simply reverse placements of Tap and Tap Accessories
18” Finished cutout
1/2” Reveal front
and back
16”
Side view applies to all
Double Bowl Workstations
Double Bowl Workstations
10”
IWS 7D
IWS 6D
IWS 5D
SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE
(Recommendations are based on installing 3 or more Tap accessories)
Galley Tap 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Galley Soap Dispenser 1" min hole diameter
Galley Deck Switch 1 3/8" min hole diameter or Galley Automatic Strainer Basket knob 1" min and 1 3/8" max hole diameter
Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Center hole diameters 2" behind cutout
Note: Galley Hot and Cold Water dispenser requires a minimum 8" clearance center to center if installed to the right of the Galley Tap
52
31
4
2
IWS 4D
Note: For installation where the drain is on the left side, simply reverse placements of Tap and Tap Accessories
Loading...