The Galley IWS-30-S, IWA-3S, IWA-30S Installation Guide
Installation Guide
Ideal Workstations®, Work&WashStations
™,
Workstations/WashStations™ with DryDock™,
BarStations
and WashStations
®
™
18” Finished cutout
1/2” Reveal front
and back
16”
Side view applies to all
Single Bowl Workstations
Single Bowl Workstations
10”
IWS 7S
IWS 2C* / IWA 2C* / IBS 2C*
IWS 30S / IWA 30S
IWS 6S
IWS 5S
IWS 3S / IWA 3S
SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE
(Recommendations are based on installing 3 or more Tap accessories)
Galley Tap 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Galley Deck Switch 1 3/8" min hole diameter or Galley Automatic Strainer Basket knob 1" min and 1 3/8" max hole diameter
Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Galley Soap Dispenser 1" min hole diameter
Center hole diameters 2" behind cutout
Note: Galley Hot and Cold Water dispenser requires a minimum 8" clearance center to center if installed to the right of the Galley Tap
1
1
2
2
2
3
3 4
*IWS 2C SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE
Galley Deck Switch 1 3/8" min hole diameter or Galley Soap Dispenser 1" min hole diameter
Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
1
IWS 4S / IWA 4S
1 2
2
Note: For installation where the drain is on the left side, simply reverse placements of Tap and Tap Accessories
Double Bowl Workstations / Work&WashStations
18” Finished cutout
1/2” Reveal front
and back
10”
16”
Side view applies to all
Double Bowl Workstations
and Work&WashStations
IWS 7D / IWW 7D
™
IWS 6D / IWW 6D
IWS 5D / IWW 5D
SUGGESTED GALLEY TAP AND TAP ACCESSORIES PLACEMENT GUIDE
(Recommendations are based on installing 3 or more Tap accessories)
Galley Tap 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Galley Soap Dispenser 1" min hole diameter
Galley Deck Switch 1 3/8" min hole diameter or Galley Automatic Strainer Basket knob 1" min and 1 3/8" max hole diameter
Galley Hot and Cold Water Dispenser 1 3/8" min hole diameter (1 1/2" min hole diameter for fast water jet cut)
Center hole diameters 2" behind cutout
Note: Galley Hot and Cold Water dispenser requires a minimum 8" clearance center to center if installed to the right of the Galley Tap
52
31
4
2
IWS 4D / IWW 4D / IWA 4D
Note: For installation where the drain is on the left side, simply reverse placements of Tap and Tap Accessories
Loading...