INSTRUCTION MANUAL
910
Wire Dispenser
Read and understand all of the instructions and
safety information in this manual before operating
or servicing this tool.
Register this product at www.greenlee.com
52042771 REV 1 © 2010 Greenlee Textron Inc. 6/10
910 Wire Dispenser
Table of Contents
Description .................................................................... 2
Safety ............................................................................ 2
Purpose of this Manual ................................................. 2
Important Safety Information ........................................ 3
Parts List ....................................................................... 4
Specications ................................................................ 4
Operation ...................................................................... 4
Description
The Greenlee 910 Wire Dispenser is intended for
transporting and dispensing wire from wire spools.
For more information, refer to “Specications” on
page4.
Safety
Safety is essential in the use of Greenlee tools and
equipment. This instruction manual and any markings
on the tool provide information for avoiding hazards and
unsafe practices related to the use of this tool. Observe
all of the safety information provided.
Purpose of this Manual
This manual is intended to familiarize all personnel with
the safe operation for the Greenlee tool:
910 Wire Dispenser
Keep this manual available to all personnel.
Replacement manuals are available upon request at
no charge at www.greenlee.com.
All specications are nominal and may change as design
improvements occur. Greenlee Textron Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
KEEP THIS MANUAL
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
2
IMPORTANT SAFETY INFORMATION
SAFETY
ALERT
SYMBOL
This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, dened below,
indicates the severity of the hazard. The message
after the signal word provides information for preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
910 Wire Dispenser
Keep hands and feet clear when
loading and unloading wire spools.
Failure to oberve this precaution
may result in injury or property
damage.
Load and unload sides equally.
Load bottom spindles rst, and
unload top spindles rst. An unbalanced or top-heavy load could
cause wire dispenser to tip over,
causing injury and property damage.
Failure to observe this precaution
may result in injury or property
damage.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this precaution
may result in injury or property
damage.
• Make sure bystanders are clear of the work area
when loading, unloading or dispensing wire.
Nearby personnel can be injured if wire dispenser
falls.
• Do not use the wire dispenser for wire with
damaged spools. Damaged spools may not turn
freely and may pull over the dispenser.
• Use only on a hard, at, level surface.
• Do not exceed the rated capacity of this tool.
Failure to observe these precautions may result in
injury or property damage.
Use this tool for manufacturer’s use only. Use other
than that which is described in this manual may
result in injury or property damage.
Note: Keep all decals clean and legible, and replace
when necessary.
Greenlee / A Textron Company 4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
3
Parts List
910 Wire Dispenser
Key Part No. Description Qty
1 52034341 Base ......................................................1
2 52034342 Tree assembly ....................................... 1
3 52034343 Handle assembly ..................................1
4 Bolt, hex, 1/2-13 x 6 ............................. 1
5 Nut, Nylok, 1/2-13.................................1
6 90514882 Caster, 8" rigid ...................................... 2
7 52034349 Caster, 8" swivel lock ............................ 2
8 Screw, hex, 3/8-16 x 1 ........................12
9 Nut, hex, reg. full, 3/8-16 .................... 12
10 Washer, lock, 3/8 ................................12
11 52034350 Nipple, 1/2" conduit ............................10
12 52034357 Locknut, 1/2" conduit steel .................10
13 Hitch pin, #8 ..........................................1
14 Bolt, eye, 5/16-18 ................................. 1
15 90550293 Pin, quick-release .................................1
16 50335898 Decal, identication ..............................1
2
14
16
15
11, 12
6
13
7
4, 5
1
8, 9, 10
3
Specifications
Height ............................................. 57" (1,447.8 mm)
Width ............................................... 31.8" (807.7 mm)
Length ................................................ 40" (1016 mm)
Weight ................................................125 lb (56.7 kg)
Capacity:
Ten 18" (457 mm) diameter spools, 14.2" (360.2 mm) wide
125 lb (56.7 kg) per spindle (when balanced)
1,250 lb (567 kg) total weight (when balanced)
Operation
1. Load wire dispenser sides equally, starting at the
bottom spindles.
2. Transport the unit by hand to the desired work
location.
3. Lock the swivel casters to prevent unwanted
movement.
4. Feed wire through the wire guide and adjust to
desired position.
5. Unload wire dispenser sides equally, starting with
the top spindles and working down.
USA 800-435-0786 Fax: 800-451-2632
815-397-7070 Fax: 815-397-1865
Canada 800-435-0786 Fax: 800-524-2853
International +1-815-397-7070 Fax: +1-815-397-9247
4455 Boeing Drive • Rockford, IL 61109-2988 • USA • 815-397-7070
An ISO 9001 Company • Greenlee Textron Inc. is a subsidiary of Textron Inc.
www.greenlee.com
Printed in USA
Loading...