Texsport 14110 User Manual

support

GREEN

Instructions:

1. Remove old shock-cord from pole section

2. Place washer on one end of shock cord and tie a knot to
keep it from coming off

3. Attach other end of cord to uncoiled wire with tape

(not included)

4. Make sure poles are in the correct order and pole ends
with ferrules connect to pole ends without ferrules.

5. Insert wire with cord into pole. Take a pair of pliers and
pushing with short strokes, guide the wire and cord
through the connecting poles.

Tape

Wire

Shock Cord

6. When cord is threaded through entire pole section,
detach wire, slip washer onto shock cord then stretch
cord about 6” out of pole and tie a knot behind the
washer. Cut off excess cord.

7. Place original end caps over knots. Glue on with water­proof glue if necessary.

HOUSTON, TX 77255 USA

MADE IN CHINA

© 2010 TEXSPORT

www.texsport.com

E

NJOY OUR PRODUCTSRESPONSIBLY

ITEM 14110