Texsport 01114 User Manual
INSTRUCTIONS
Item 01114
Mountain Breeze Screen Porch Tent
Thank you for purchasing this Texsport tent. Please read and understand each step of the set-up instructions. We encourage you to set-up this tent
at least once prior to your camping trip, ensuring that you have a satisfactory understanding of the set-up process. We hope you enjoy your new
tent and that it will give you many years of camping pleasure.
Do not apply excessive force to this product.
PARTS LIST:
A
A ......Tent skin
B ......2 Sets of porch leg poles
C......2 Sets of tent poles
D......1 Porch roof pole
E......Stakes, guy ropes and
clews.
NOTE:
Prepare your camp site by removing all
sharp stones, twigs, etc. The site should be
flat and have no depressions that could collect rain water.
B
C
D
E
STEP 1 - Spread out tent skin. STEP 2 - Assemble poles (C) and
insert through the tent sleeves.
STEP 4 - Losly tie the poles at
the center of the tent skin
STEP 5 - Insert the pin and ring
into the end of the pole (C).
STEP 3 - Your poles should form
an X as shown above.
STEP 6 - Attach speed clips to
pole frame.
STEP 7 - This is how your tent
should look at this point.
STEP 8 - Assemble the porch
roof pole (D) and insert
through the porch arch sleeve.
STEP 9 - Insert roof pole into the
small opening of the attached
molded corner joint.
STEP 10 - Assemble the porch
legs (B) and insert into the
open end of the attached
molded corner joint.
STEP 11 - Insert the pin and
ring of the porch skin into the
porch leg poles.
STEP 12 - Stake down at all the
pin rings.
STEP 13 - Stake down all tabs
and front door.
STEP 16 - To attached the fly,
drap over tent and secure with
hooks into the porch legs.
STEP 14 - This is what your tent
should look like.
STEP 17 - Secure fly by hooking onto the rings at the pin
and ring.
STEP 15 - Stake down the mud
mat inside porch.
STEP 18 - Velcro fly to frame
poles.
STEP 19 - It is recommended in
windy weather to secure your
tent with guy ropes. Insert the
guy rope into clew as shown
above.
STEP 22 - Stake down
the guy rope and adjust
the tension on the guy
rope by sliding the clew
up or down.
STEP 20 - Tie the other end of
the guy rope to the tabs on the
fly.
STEP 21 - Loosen the guy rope
as shown to wrap around a
stake.
STEP 23 - This is
what your
completely built
tent should look
like.
Loading...