Texsport 01082 User Manual [en, es]

INSTRUCTIONS

Item 01082

Deluxe Camp Shower/Shelter Combo

Thank you for purchasing this Texsport shower/shelter. Please read and understand each step of the set-up instructions. We encourage you to set­up this shower/shelter at least once prior to your camping trip, ensuring that you have a satisfactory understanding of the set-up process. We
hope you enjoy your new shower/shelter and that it will give you many years of camping pleasure.

Do not apply excessive force to this product.

C

A

B

J

K

PARTS LIST:

A......1 Shower/shelter skin

B......2 Towel holder poles

C......4 Leg poles

D......4 Curved roof poles

D

E

H

I

FG

G......4 Molded corner joints

H......Solar shower

I......Stakes, clews, and guy rope

J......Towel holder straps

K......Removable floor

E......4 Eave poles

F......1 Molded roof joint

NOTE: ALL FRAME POLES HAVE A
LOCKING TAB. LINE UP THE TAB
AND SLOT ON EACH POLE FOR A
SECURE FIT.

NOTE:

Prepare your camp site by removing all sharp stones,
twigs, etc. The site should be flat and have no depres­sions that could collect rain water.

STEP 1 - Assemble the curved roof
poles (D) and insert each one into
the molded roof joint (F).

STEP 2 - Make sure all curved roof
poles are secure as shown above.

STEP 3 - Insert the curved roof
poles into the molded corner joints
(G).

STEP 4 - Assemble the eave poles
(E) and insert each one into the
molded corner joint.

STEP 5 - Make sure all poles have
snapped into their locking tab for
a secure fit as shown above.

STEP 6 - Assemble ONLY the top 2
sections of the leg poles (C). The
top section will have a small hole.

STEP 7 - Insert the top section of
the leg poles into the bottom sock­ets of the molded corner joints.

STEP 8 - This is what your frame
should look like at this point.

STEP 9 - Spread the shower/shel­ter skin and locate the web loop at
the top of the skin.

STEP 12 - This is what your frame
should look at this point.

STEP 10 - Hook the web loop onto
the molded roof joint.

STEP 13 - Connect the last section
of the leg poles and insert the pin
and ring into the bottom of each
leg pole.

STEP 11 - Attach the speed clips to
the frame.

STEP 14 - Stake down all 4 sides
of the shower/shelter at the rings.

STEP 15 - This is what your
shower/shelter should look like
without the fly or other acces­sories.

STEP 18 - Secure your
shower/shelter combo by using
guy ropes. Insert the guy rope into
the clews and knot the end as
shown above.

STEP 16 - Drape fly over
shower/shelter and insert the at­tached hooks into the small holes
on the leg poles as shown above.

STEP 19 - Tie the other end of the
guy rope onto the fly loops.

STEP 17 - This is what your
shower/shelter with fly should
look like.

STEP 20 - Loop the guy rope
around a stake and insert into the
ground.