Texas Instruments ZLIGHT2 Users Manual

SWRUXXX
FCC and IC certified and
over
ESD
sensitive components. Handle with
Once connected to the ZLL network through
touch linking, the Zlight2 can be controlled by
sure that air is allowed to
circulate freely around the
Zlight2 board when operating.
Feb 2013
Zlight2 Quick Start Guide
Opening the box and adding the light to a ZLL network
1. Kit Contents
1 x Zlight2 LED light
Documentation
The Zlight2 is tested/complies with ETSI/R&TTE temperature from 0 to +35°C. The antenna is an on-board half wave dipole PCB antenna.
Caution! The kit contains
2. Hardware Requirements
To run the example described in this Quick Start Guide, you need a USB power supply capable of supplying at least 800mA and max 5.5V, a type A to micro-USB cable to connect it to the light, and a ZigBee Light Link (ZLL) remote control.
3. Powering the board
Connect the Zlight2 board to the USB power supply through the type A to micro-USB cable (not included).
Caution! To minimize risk of injury, avoid touching components during operation if symbolized as hot.
Do not leave the EVM powered when unattended.
care to prevent permanent damage.
4. Touch linking
Touch link the Zlight2 lamp by holding the remote control close to the top of the lamp and following the instructions provided with the ZLL remote control
5. Operating the Zlight2
the remote control unit. Please follow the remote control user guide.
Caution! To minimize the risk of fire or equipment damage, make
Avoid touching components during operation if symbolized as hot.
Web sites: www.ti.com/lprf E2E Forum: www.ti.com/lprf-forum
Make sure to subscribe to the Low-Power RF Newsletter to receive information about updates to documentation, new product releases, and more. Sign up on the TI web pages.
The CC debugger is a tool that allows you to flash
Programmer or IAR Embedded Workbench. It
connects to a USB port on your PC and to the
Additional Tools and Links
CC debugger
and debug the Zlight2 using SmartRF Flash
debug header on the Zlight2 board.
Useful Links
SmartRF Flash Programmer
Texas Instruments has a simple tool which can be used to program and flash the Zlight2.
SmartRF Flash Programmer can be downloaded from www.ti.com/tool/flash-
programmer
Useful Links
CC2531 User’s Guide:
http://www.ti.com/lit/ug/swru191c/swru191c.pdf
For additional help, visit the TI E2E Forums:
www.ti.com/lprf-forum
IAR Embedded Workbench
To develop software, program, and debug the Zlight2, you should use IAR Embedded Workbench for 8051.
More information on IAR EW8051, including a free evaluation version download, can be found at
www.iar.com/ew8051.
Loading...
+ 4 hidden pages