Texas Instruments SN74AHC541DBLE, SN74AHC541DBR, SN74AHC541DGVR, SN74AHC541DW, SN74AHC541DWR Datasheet

SN54AHC541, SN74AHC541

OCTAL BUFFERS/DRIVERS

WITH 3-STATE OUTPUTS

SCLS261K – DECEMBER 1995 – REVISED JANUARY 2000

D

EPIC

 (Enhanced-Performance Implanted

CMOS) Process

D

Operating Range 2-V to 5.5-V V

D

Latch-Up Performance Exceeds 250 mA Per

CC

JESD 17

D

Package Options Include Plastic
Small-Outline (DW), Shrink Small-Outline
(DB), Thin Very Small-Outline (DGV), Thin
Shrink Small-Outline (PW), and Ceramic
Flat (W) Packages, Ceramic Chip Carriers
(FK), and Standard Plastic (N) and Ceramic
(J) DIPs

description

The ’AHC541 octal buffers/drivers are ideal for
driving bus lines or buffer memory address
registers. These devices feature inputs and
outputs on opposite sides of the package to
facilitate printed circuit board layout.

The 3-state control gate is a two-input AND gate
with active-low inputs so that if either
output-enable (OE1
corresponding outputs are in the high-impedance
state. The outputs provide noninverted data when
they are not in the high-impedance state.

T o ensure the high-impedance state during power
up or power down, OE
through a pullup resistor; the minimum value of
the resistor is determined by the current-sinking
capability of the driver.

or OE2) input is high, all

should be tied to V

CC

SN74AHC541 . . . DB, DGV, DW, N, OR PW PACKAGE

SN54AHC541 ...J OR W PACKAGE

(TOP VIEW)

Y8

20
19
18
17
16
15
14
13
12
11

V

CC

Y7

V

CC

OE2
Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8

18
17
16
15
14

Y6 OE2

Y1
Y2
Y3
Y4
Y5

OE1

1
2

A1

3

A2

4

A3

5

A4

6

A5

7

A6

8

A7

9

A8

GND

SN54AHC541 . . . FK PACKAGE

10

(TOP VIEW)

A2A1OE1

A3
A4
A5
A6
A7

3212019

4
5
6
7
8

910111213

A8

GND

The SN54AHC541 is characterized for operation
over the full military temperature range of –55°C
to 125°C. The SN74AHC541 is characterized for
operation from –40°C to 85°C.

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

EPIC is a trademark of Texas Instruments Incorporated.

PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

FUNCTION TABLE

(each buffer/driver)

INPUTS

OE1 OE2 A

L L L L

L LH H
H XX Z
X H X Z

OUTPUT

Y

Copyright  2000, Texas Instruments Incorporated

On products compliant to MIL-PRF-38535, all parameters are tested
unless otherwise noted. On all other products, production
processing does not necessarily include testing of all parameters.

1

SN54AHC541, SN74AHC541
OCTAL BUFFERS/DRIVERS
WITH 3-STATE OUTPUTS

SCLS261K – DECEMBER 1995 – REVISED JANUARY 2000

logic symbol

†

This symbol is in accordance with ANSI/IEEE Std 91-1984 and IEC Publication 617-12.

†

OE1
OE2

A1
A2
A3
A4
A5
A6
A7
A8

1
19

2
3
4
5
6
7
8
9

&

EN

1

logic diagram (positive logic)

1

OE1

19

OE2

18
17
16
15
14
13
12
11

Y1
Y2
Y3
Y4
Y5
Y6
Y7
Y8

218

A1

To Seven Other Channels

Y1

absolute maximum ratings over operating free-air temperature range (unless otherwise noted)

Supply voltage range, VCC –0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Input voltage range, VI (see Note 1) –0.5 V to 7 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output voltage range, V

Input clamp current, IIK (VI < 0) –20 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Output clamp current, IOK (VO < 0 or VO > VCC) ±20 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous output current, IO (VO = 0 to VCC) ±25 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Continuous current through VCC or GND ±75 mA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Package thermal impedance, θ

Storage temperature range, T

‡

Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only, and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.

NOTES: 1. The input and output voltage ratings may be exceeded if the input and output current ratings are observed.

2. The package thermal impedance is calculated in accordance with JESD 51.

(see Note 1) –0.5 V to VCC + 0.5 V. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

O

(see Note 2): DB package 70°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

JA

DGV package 92°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

DW package 58°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

N package 69°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

PW package 83°C/W. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

–65°C to 150°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

stg

‡

2

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

UNIT

mA

mA

∆t/∆vInput transition rise or fall rate

ns/V

PARAMETER

TEST CONDITIONS

V

UNIT

OH

OL

SN54AHC541, SN74AHC541

OCTAL BUFFERS/DRIVERS

WITH 3-STATE OUTPUTS

SCLS261K – DECEMBER 1995 – REVISED JANUARY 2000

recommended operating conditions (see Note 3)

SN54AHC541 SN74AHC541

MIN MAX MIN MAX

V

V

V

V
V

I

OH

I

OL

T

NOTE 3: All unused inputs of the device must be held at VCC or GND to ensure proper device operation. Refer to the TI application report,

Supply voltage 2 5.5 2 5.5 V

CC

VCC = 2 V 1.5 1.5

High-level input voltage

IH

Low-level input voltage

IL

Input voltage 0 5.5 0 5.5 V

I

Output voltage 0 V

O

High-level output current

Low-level output current

p

Operating free-air temperature –55 125 –40 85 °C

A

Implications of Slow or Floating CMOS Inputs

, literature number SCBA004.

VCC = 3 V
VCC = 5.5 V 3.85 3.85
VCC = 2 V 0.5 0.5
VCC = 3 V
VCC = 5.5 V 1.65 1.65

VCC = 2 V –50 –50
VCC = 3.3 V ± 0.3 V
VCC = 5 V ± 0.5 V –8 –8
VCC = 2 V 50 50
VCC = 3.3 V ± 0.3 V
VCC = 5 V ± 0.5 V 8 8
VCC = 3.3 V ± 0.3 V 100 100
VCC = 5 V ± 0.5 V 20 20

2.1 2.1

0.9 0.9

CC

–4 –4

4 4

0 V

CC

V

V

V

m

A

m

A

electrical characteristics over recommended operating free-air temperature range (unless
otherwise noted)

CC

2 V 1.9 2 1.9 1.9

IOH = –50 mA

V

OH

IOH = –4 mA
IOH = –8 mA

IOL = 50 mA

V

OL

IOL = 4 mA
IOL = 8 mA

I

I

†

I

OZ

I

CC

C

i

C

o

* On products compliant to MIL-PRF-38535, this parameter is not production tested at VCC = 0 V.
†

For input and ouput, IOZ includes the input leakage current.

VI = VCC or GND 0 V to 5.5 V ±0.1 ±1* ±1
VO = VCC or GND,

VI (OE

) = VIL or V
VI = VCC or GND, IO = 0 5.5 V 4 40 40
VI = VCC or GND 5 V 2 10 10 pF
VO = VCC or GND 5 V 4 pF

IH

3 V 2.9 3 2.9 2.9

4.5 V 4.4 4.5 4.4 4.4
3 V 2.58 2.48 2.48

4.5 V 3.94 3.8 3.8
2 V 0.1 0.1 0.1
3 V 0.1 0.1 0.1

4.5 V 0.1 0.1 0.1
3 V 0.36 0.5 0.44

4.5 V 0.36 0.5 0.44

5.5 V ±0.25 ±2.5 ±2.5

TA = 25°C SN54AHC541 SN74AHC541

MIN TYP MAX MIN MAX MIN MAX

V

V

m

A

m

A

m

A

POST OFFICE BOX 655303 • DALLAS, TEXAS 75265

3