Page 1
Technical Description and
Operating Instructions
Speaker stand
AC 1001 SP
General notes and information
Proper use
Only use the speaker stand for mounting suitable speakers. You can nd a corresponding list on our website
www.teufelaudio.com. Any other use will be deemed as not in
accordance with the instructions and may lead to damage of
property or even persons.
The manufacturer accepts no liability for damage caused by
use not in accordance with the
intended for private use.
Before operating the product for the rst time, please
read the safety notes and operating instructions care-
fully. This is the only way to use all functions safely
and reliably. Keep the operating instructions safe and pass
them on to anyone who may own the unit after you.
Notice
The information in this document may change without prior
notice and in no way constitutes any liability on the part of
Lautsprecher Teufel GmbH. No part of these instructions may
be reproduced in any form or be broadcasted in any way electronically, mechanically, by photocopy or recording without the
written permission of Lautsprecher Teufel GmbH.
instructions. The product is
Original packaging
If you wish to exercise your eight-week right of return, we ask
that you be absolutely sure to hold onto the packaging. We can
only accept the return of a unit WITH THE ORIGINAL PACKAGING. Empty boxes are not available!
Complaints
In case of a complaint we implicitly need your invoice number
and the serial or lot number for processing. The serial number
is located on the bottom side of the device.
Many thanks for your support!
Contact
For questions, suggestions or any other issues please contact
our customer service department:
Lautsprecher Teufel GmbH
Gewerbehof Buelowbogen
Buelowstrasse 66
10783 Berlin (Germany)
Phone 00800 - 200 300 40 (toll-free)
Fax: +49 (0)30 / 300 930 930
E-Mail: service@teufelaudio.com
www.teufelaudio.com
Page 2
Safety notes
Danger
• Place the speakers in such a way that they cannot be
• Do not place the speakers near or directly above sources of
• Avoid direct sunlight at the setup location.
Danger of injury/damage!
Incorrect location may result in damage.
knocked over unseen and make sure that the cables do not
pose a trip hazard.
heat (e.g. heaters, ovens, other heat generating equipment
such as ampliers etc.).
Product contents
a 2 x pipe
b 2 x speaker bracket
c 2 x xing nut
d 2 x holding screw
e 4 x xing screw
f 2 x base plate
Check that all items have been delivered and that nothing is
damaged.
If anything is missing or damaged, please contact our service
department (see page 1). Do not use a product if it is damaged.
Danger
• Do not allow children to play with the unit or the packing
• Ensure that children do not remove small parts from the
Danger to children!
Children can become trapped in the packing lm
when playing and suffocate.
lm. Danger of suffocation.
unit or take them off of the unit (e.g. control knobs or plug
adapters). They could swallow the parts and choke.
a
b
Note:
You can nd a current list with all the speakers that are
suitable for use with this speaker stand on our website at
www.teufelaudio.com.
c
d
e
f
Page 3
Assembly
Depending on the construction of your speakers there are 2
possibilities for mounting:
a
f
1. Screw the pipe a into the base plate f.
b
e
A) For speakers with a key hole opening
c
d
1. Insert the holding screw d into the speaker bracket from
the front and rst screw it loosely together with the xing
nut c.
2. Use the key hole opening to carefully hang the speaker on
the holding screw. Then rmly tighten the xing nut.
3. Connect the speaker cables as described in the operating
instructions for the speakers.
B) For speakers with a threaded insert
2. Place the speaker bracket b on the upper end of the pipe
and x it in place with the xing screw e.
3. Run the speaker cable through the upper hole and through
the pipe until it extends somewhat out of the opening in
the base plate. Then pull it through until there is sufcient
length left for connecting the speaker at the top.
e
1. Screw the speaker onto the speaker stand with the xing
screw e until secure.
2. Connect the speaker cables as described in the operating
instructions for the speakers.
Page 4
Technical data
Max. carrying capacity: 2 kg
Height: 960 mm
Diameter of base plate: 220 mm
You can obtain further technical data on our website.
This product conforms with Council of the European
Union guidelines 2004/108/EC and 2006/95/EC.
Lautsprecher Teufel GmbH
Gewerbehof Buelowbogen – Aufgang D1
Buelowstr. 66, 10783 Berlin (Germany)
www.teufelaudio.com
Phone: 00800- 200 300 40
(toll-free)
Fax: +49 (0)30 / 300 930 930
No responsibility is assumed for the correctnes s of this information. Technical change s, typographical errors and other errors reserved. Instruction No. 92349 GB 20130312 / HC -HAM
Loading...