LIMITED ONE YEAR WARRANTY:
United Pet Group, Inc. (UPG) warrants this LED Light Stick
Assembly against defects in material or workmanship for one year from the date of original purchase,
subject to the conditions and exceptions stated below. Your sales receipt is your Proof-of-Date-of-Purchase.
If the LED Stick Assembly exhibits such a defect, UPG will repair or replace it, at UPG’s option, without
cost for parts or labor. The LED Stick Assembly must be shipped postage paid to UPG. Proof-of-Dateof-Purchase is required. You are responsible for proper shipping. Call Customer Service at 800-5260650 for return authorization and shipping address.This warranty does not cover damage caused
by accident, misuse, abuse or failure to follow the instructions accompanying LED Stick Assembly.
All implied warranties, including any implied warranty of merchantability or fitness for any purpose are
limited to one year. Fish and plant loss, personal injury, property loss or damage (direct, incidental, or
consequential) resulting from the use of the LED Light Stick are not covered by this warranty. Because some
states/provinces do not allow the exclusion or limitation of incidental or consequential damages, or allow
limitations on how long an implied warranty lasts, the above limitations or exclusion may not apply to
you. This warranty gives you specific legal rights. You may also have other rights which vary from state/
province to state/province.
06/14 P/N 52714 Rev. A
If the LED lights fall into the water:
This LED light is waterproof. Simply remove the LED Light
from the water and attach it to the frame using the LED frame clip.
Troubleshooting Guidelines
Distributed by United Pet Group, Inc.
3001 Commerce St,
Blacksburg, VA 24060
IMPORTANT SAFEGUARDS
WARNING: To guard against injury, basic safety precautions should be observed, including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
DANGER: To avoid possible electric shock, special care should be taken since water is
employed in the use of aquarium equipment. For each of the following situations, do not
attempt repairs by yourself; return the appliance to an authorized service facility for service or
discard the appliance:
1. A. If an appliance falls into the water, DON’T reach for it! First unplug it and then
retrieve it. If electrical components of the appliance get wet, unplug the appliance
immediately. If the filter shows any sign of abnormal water
leakage, immediately unplug it from the power source.
B. Carefully examine the appliance after installation. It should
not be plugged in if there is water on parts not intended to
be wet.
C. Do not operate any appliance if it has a damaged cord
or plug, or if it is malfunctioning or has been dropped or
damaged in any manner.
D. To avoid the possibility of the appliance plug or receptacle
getting wet, position aquarium stand and tank to one
side of a wall-mounted receptacle to prevent water from
dripping onto the receptacle or plug. A drip loop, shown
in the figure below, should be arranged by the user for each cord connecting an
aquarium appliance to a receptacle. The drip loop is that part of the cord below
the level of the receptacle, or the connector if an extension cord is used, to prevent
water traveling along the cord and coming in contact with the receptacle.
E. If the transformer or receptacle does get wet, DON’T unplug the cord. Disconnect
the fuse or circuit breaker that supplies power to the appliance. Then, unplug and
examine for presence of water in the receptacle.
2. Close supervision is necessary when any appliance is used by or near children.
3. To avoid injury, do not contact moving parts or hot parts such as heaters, reflectors,
lamp bulbs, and the like.
4. Always unplug an appliance from an outlet when not in use, before putting on or taking
off parts, and before cleaning. Never yank cord to pull plug from outlet. Grasp the plug
and pull to disconnect.
5. Do not use an appliance for other than intended use. The use of attachments not
recommended or sold by the appliance manufacturer may cause an unsafe condition.
6. Do not install or store the appliance where it will be exposed to the weather or to
temperatures below freezing.
7. Make sure an appliance mounted on a tank is securely installed before operating it.
8. Read and observe all the important notices on the appliance.
9. If an extension cord is necessary, a cord with a proper rating should be used. A cord
rated for less amperes or watts than the appliance rating may overheat. Care should be
taken to arrange the cord so that it will not be tripped over or pulled.
SAVE THESE INSTRUCTIONS
APPLIANCE
AQUARIUM
POWER
CORDS
DRIP
LOOPS
APPLIANCE
Install LED Light
2
A. Clip Waterproof LED Light into the front
of the aquarium frame.
B. Hide wires with cord routing clips.
C. Plug in and make a drip loop
for safety.
Waterproof LED Light
Cord
Routing Clips
Drip Loop
B
C
A
Note: For models that have two sticks the connecting wire must be routed
under the tank center brace
Waterproof LED Light
Cord
Routing Clips
Drip Loop
B
C
A
Waterproof
LED Light
LED
Frame Clip
Light Switch
Low Voltage
Transformer
Cord Routing
Clips (2)
Parts Check
Start Here - LED Light Sticks
Quick Setup Guide
1
Questions or Missing Parts Call Customer Service (800) 526-0650
M-F 7:30 a.m. - 5:30 p.m. (Eastern Time) www.tetra-fish.com
© 2014 United Pet Group, Inc.
Note: Some models have two LED lights
Waterproof
LED Lights
LED
Frame Clip
Light Switch
Low Voltage
Transformer
Cord Routing
Clips (2)
Loading...