Terrestrial Digital Lacrosse Assembly Instructions Manual

Lacrosse HDTV Antenna Assembly Instructions

The Lacrosse HDTV antenna is optimized
for digital reception. It has its greatest
performance on the UHF band (ch
14-69) where most of the digital stations
are broadcast. It will also have capability
on upper VHF (7-13) channels as well.

The Lacrosse has very flexible aiming
characteristics with an average beam­width of 90 degrees.

Assembly

1. Connect coax cable to connection on bottom of antenna

2. Attach pipe and foot where you plan on installing the antenna

3. Attach tilt bracket assembly to back of antenna using screws provided (as shown)

Built in Amplifier (Amplified version only)

Disregard this step if you have the non amplified version. On the Lacrosse A, There
is a built-in low noise pre amplifier. You do not need to run electricity to the
antenna. Power comes from an external power inserter (supplied). The power
inserter supplies 18volts to the antenna via regular coax cable

Connect the power inserter to the antenna where it says “To booster” then connect
the power inserter to your digital tuner via “to TV” output.

Warning to reduce the risk of fire or electrical shock, do not
expose power inserter to rain or moisture.