Terrco 3100-3P Operating Instructions Manual

®

Terrco

Model 3100-3P

, Inc.

OPERATING INSTRUCTIONS

MAINTENANCE INSTRUCTIONS

ILLUSTRATED PARTS LIST

222 1st Avenue NW • Watertown, SD 57201

Phone: [phone] • Fax: [phone] • Email: [e-mail]

Terrco®, Inc.

Model 3100-3P

HP/KW 25/18.6

SWEEP OF DISCS 28” (711 mm)

ABRASIVE PRESSURE 1090 lbs (494 kg)

WIDTH OF MACHINE 29-1/2” (749 mm)

LENGTH OF MACHINE 72-1/4” (1835 mm)

HEIGHT OF MACHINE 52” (1321 mm)

NET WEIGHT 1425 lbs (646 kg)

SHIPPING WEIGHT 1625 lbs (737 kg)

WATER TANK 20 gallon (75,7 L)

POWER CORD (4-4) 100 ft (30,5 m)

ELECTRICAL OPTIONS

VOLTAGE 230 230 460 460

PHASE 3 3 3 3

DRIVE MANUAL VARIABLE VARIABLE MANUAL

AMP DRAW 60 60 30 30

BREAKER (AMPS) 80-100 80-100 50 50

STONE HOLDER RPM 510 385-600 385-600 510

Optimal for jobs exceeding 10,000 sq. ft.
Despite the weight and size the 3100 can be easily maneuvered by a single person
Uses Plug Stone Shape, Bolt on to Universal Tool Plate, or Speed Shift System
Four 42 lbs. Pocket Weights
Mild Steel or Stainless Steel Guards
Stainless Steel Water Tank
Wet/Dry Setup

PRODUCTION RATES

Mastic removal rate of 1000 sq. ft. per hour
Thin-Set removal rates of 1,500 sq. ft. per hour
Thin-Mil coatings removal of 750 sq. ft. per hour
Concrete polishing rates of 2,500 sq. ft. per polishing pad per hour (depending on grit)
Rough Terrazzo rate of 1,500 sq. ft. per day

222 1st Avenue NW • Watertown, SD 57201

Phone: [phone] • Fax: [phone]

Email: [e-mail] • Website:www.terrco.com

--------------------------------­SAFTY PRECAUTIONS

-----------------------------------------------------------

This machine is intended for commercial use. It is designed
exclusively to grind and polish Terrazzo and concrete floors.
Use only recommended accessories and abrasives.
When the machine is in need of repair, use only Terrco parts.
All operators must read, understand and practice the following
safety precautions.

WARNING: Rotating grinding wheels can cause injury, keep

hands and loose clothing clear.

WARNING: Disconnect power at the machine before servicing

or changing grinding stones.

WARNING: Always check ground (earth) connection prior to

operating machine.

For Safety:
1: Have electrician hook up power to machine.
2: Always operate machine with ground fault protection.
3: Eye, hearing and respiratory protection advised.
4: Service and adjust guards for maximum protection. Never remove the guards.
5: Keep machine clean and properly serviced.