TerraWave T24235G10006T User Manual

TerraWave Solutions® 2.4-2.5 GHz 23.5 dBi Parabolic Grid Antenna with N-Style Jack Connector

TerraWave's 2.4-2.5GHz 23.5 dBi directional grid antenna provides an excellent gain and a low beamwidth,
making it ideal for outdoor point-to-point communications or as a bridge antenna between two networks.
It can be mounted in either a horizontal or vertical polarization. The reflector grid is constructed from high
quality die cast aluminum, giving the antenna's signal superior strength and power. Includes a durable mount
kit. All TerraWave antennas are covered by the Company’s two-year TerraNet warranty program. For ques­tions and to purchase product, contact a wireless networking solutions sales engineer at 210-375-8482, 800­851-4965 or [e-mail]. Visit www.terrawave.com for additional information.

Specifications

Model T24235G10006T
Frequency Range 2400 - 2500 MHz
Bandwidth 100 MHz
Gain 23.5 dBi
Vertical Beamwidth 7.5°
Horizontal Beamwidth 11°
VSWR ≤ 1.5
Front-to-back Ratio ≥ 30 dB
Nominal Impedance 50 Ohms

Polarization Vertical
Max Power 100 Watts
Connector N-Style Jack (Female)
Dimensions 38.9

" (W) x 23.6" (H)

Weight 9.24 lbs
Wind Load 120 mph
Mast Mount Diameter 1.5” - 2.0”

Operating Temperature Range

E-Plane Pattern H-Plane Pattern

www.terrawave.com Email: [e-mail] Phone: [phone] Fax: [phone] 10521 Gulfdale, San Antonio, TX 78216

-40°F ～158°F

TerraWave Solutions® 2.4-2.5 GHz 23.5 dBi Parabolic Grid Antenna with N-Style Jack Connector

Mounting Bracket Information for T24235G10006T

1. Assemble the two piece grid reflectors with screws and nuts.
*Tip* - Install the screws/nuts at the grid’s end. Do not install the screws/nuts at the
center piece until step 2.

2. Mount the antenna feeder and the “L” bracket to the grid reflector.
*Note* - There is an arrow on a sticker at the feeder’s end.
Make sure the arrow is parallel to the antenna’s grids.

3. Polarization
a. Vertical polarization: The arrow must be pointing vertically to the ground. The antenna’s
grids should be vertical to the ground after installation.
b. Horizontal polarization: The arrow must be pointing parallel to the ground. The antenna’s
grids should be parallel to the ground after installation.

3. Use the “L” bracket to mount the antenna to the mast.

4. Adjust the antenna angle until signal reception is optimized.

5. Fasten all screws and nuts provided in the package.

6. Seal the connector jointing parts with waterproof tape.

www.terrawave.com Email: [e-mail] Phone: [phone] Fax: [phone] 10521 Gulfdale, San Antonio, TX 78216