TerraKing TKV 20 Operator's Manual
OPERATOR’S MANUAL
TKV 20 Material Collection System
TK95044
8/8/2018
For your safety, please read and save all
safety and operating instructions prior to
using equipment.
Introduction
Table of Contents
Introduction .................................................................... 2
Product Compatibility .................................................... 2
Safety Labels ..............................................................3-5
Safety ............................................................................. 6
Parts in Kit ..................................................................... 7
Tractor and Other Requirements ................................... 7
Assembly .................................................................. 8 -11
Operation ..................................................................... 12
Troubleshooting ...................................................... 13-14
Maintenance ........................................................... 15-17
Specifications ............................................................... 18
Warranty ....................................................................... 20
Using Your Operator’s Manual
Read this entire manual in its entirety, especially the safety
information, before operating.
Product Compatibility
The TKV 20 is designed for use on sub-compact and
compact tractors with mid-mount side discharge mower
decks. Refer to the Tractor Requirements section
on page 7 and to your tractor’s operators manual to
determine compatibility.
This manual is an important part of your TKV 20 Material
Collection System (MCS). Keep this manual in a
convenient location so that it can be accessed easily.
Use the safety and operating information in this manual
in order to operate and service the attachment safely and
correctly.
If you have any questions or concerns with the assembly,
installation, or operation of the TKV 20, contact TerraKing
at 717-286-1444 or sales@terraking.com.
Warranty information regarding the TKV 20 can be found in
the Warranty section of this manual.
2
Safety Labels
ST48295
ST48453
AVOID INJURY FROM
MOVING PARTS
• Do not operate without
hose connected
• Disconnect PTO
before servicing
AVOID INJURY FROM
MOVING PARTS
• Keep hands, fingers
and feet away
• Disconnect power
before servicing
ST48454
Understanding the Machine Safety Labels
Safety labels shown in this section are placed in
important areas on your machine to draw attention to
potential safety hazards.
On your machine safety labels, the words DANGER,
WARNING, and CAUTION are used with this safety-alert
symbol. DANGER identies the most serious hazards.
AVOID INJURY FROM
MOVING PARTS
• Do not operate without
shields in place
• Disconnect PTO
before servicing
DANGER
ROTATING DRIVELINE:
CONTACT CAN CAUSE D EATH
KEEP AWAY!
DO NOT OPERATE WITHOUT:
• All driveline guards, tract or and equipment
shields in place
• Drivelines securely att ached at both ends
• Driveline guards that turn fr eely on driveline
Be sure to replace missing or damaged safety labels.
Use this manual for correct safety label placement.
Additional safety information on parts and components
sourced from suppliers might not be represented in this
section.
This manual explains potential safety hazards whenever
necessary in special messages that are identied with the
word, CAUTION, and the safety-alert symbol.
3
Safety Labels
WARNING
To Avoid Injury From Thrown Objects
• Keep bystanders away
• Shut off engine before opening hopper top
• Keep chutes in place
• Never allow riders on hopper top or on frame
• Disconnect power before servicing
AVOID INJURY FROM
MOVING PARTS
• Do not operate without
hose connected
• Disconnect PTO
before servicing
ST48454
WARNING
To Avoid Injury From Moving Parts
• Do not operate without hose connected
• Disconnect PTO shaft before servicing
CAUTION
To Avoid Injury
• Install front ballast per tractor’s operator’s manual
DANGER
Bagger May Impair Rear Vision
• Look down and behind before and while backing
AVOID INJURY FROM
MOVING PARTS
• Keep hands, fingers
and feet away
• Disconnect power
before servicing
ST48295
WARNING
Avoid Injury From Moving Parts
• Keep hands, feet and clothing away
• Disconnect mechanical and electrical power
before servicing
4
Safety Labels
AVOID INJURY FROM
MOVING PARTS
• Do not operate without
shields in place
• Disconnect PTO
before servicing
DANGER
ST48453
WARNING
To Avoid Injury From Moving Parts
• Do not operate without shields in place
• Disconnect PTO shaft before servicing
CAUTION
No Step
• Do not step, stand or sit on this surface
• Improper use may cause injury and/or equipment damage
ROTATING DRIVELINE:
CONTACT CAN CAUSE DEATH
KEEP AWAY!
DO NOT OPERATE WITHOUT:
• All driveline guards, tractor and equipment
shields in place
• Drivelines securely attached at both ends
• Driveline guards that turn freely on driveline
DANGER
Rotating Driveline: Contact Can Cause Death
Keep Away!
Do Not Operate Without:
• All driveline guards, tractor and equipment
shields in place
• Drivelines securely attached at both ends
• Driveline guards that turn freely on driveline
5
Safety
PLEASE READ: CRITICAL SAFETY WARNINGS
• DO NOT operate with the Steel Coil Hose off or
with the Cleanout Door open.
• DO NOT remove the Steel Coil Hose or open the
Cleanout Door while the tractor is running.
• DO NOT get near the rear of the tractor when the
PTO is engaged.
• DO NOT operate without front ballast.
General Safety
• The TKV 20 is limited to collecting only grass or leaves.
• Be aware when maneuvering your machine because
the TKV 20 increases vehicle length and also alters its
center of gravity.
• Be aware of the potential pinch point when closing
the tailgate and lid.
• DO NOT allow anyone to ride in or on the TKV 20.
Operating Safely
• Read the tractor and this operator’s manual carefully.
Be thoroughly familiar with the controls and the
proper use of the equipment. Know how to stop the
tractor and disengage the controls quickly.
• The TKV 20 is only intended for use in lawn and property
maintenance applications. TerraKing does not advise
or recommend this product for any other uses.
• Do not modify the TKV 20’s safety devices. Unauthorized
modifications may impair its function, safety, and
void the warranty.
• Do not let children or an untrained person
operate machine.
• Make any necessary adjustments before you
operate. Never attempt to make any adjustments
while the engine is running, unless if recommended
in adjustment procedure.
• Look behind machine before and while you back up.
Back up carefully.
• Do not let anyone, especially children, ride on
machine or attachment. Riders are subject to injury
such as being struck by foreign objects and being
thrown off. Riders may also obstruct the operator’s
view and alter weight distribution, resulting in the
machine being operated in an unsafe manner.
• Disengage any power to the attachment when the
machine is transported or not in use.
Parking Safety
1. Stop machine on a level surface
2. Lock the park brake
3. Stop the engine
4. Remove the key
5. Wait for engine and all moving parts to stop before
leaving the operator’s seat
Practice Safe Maintenance
• Only qualified, trained adults should service this machine.
• Understand service procedure before doing work.
Keep area clean and dry.
• Do not operate the engine in a confined space where
dangerous carbon monoxide fumes can collect.
• Never lubricate, service or adjust the machine or
attachment while it is moving. Keep safety devices in
place and in working condition. Keep hardware tight
and check regularly.
• Keep hands, feet, clothing, jewelry, and long hair away from
any moving parts, to prevent them from getting caught.
• Lower the TKV 20 completely to the ground or to an
existing attachment mechanical stop before servicing.
Disengage all power and stop the engine. Lock park
brake and remove the key. Let machine cool.
• Before servicing machine or attachment, carefully
release pressure from any components with stored
energy, such as hydraulic components and springs.
• Release hydraulic pressure by lowering attachment
or cutting units to the ground or to a mechanical stop
and move hydraulic control levers.
• Securely support any machine or attachment elements that
must be raised for service work. Use jack stands or lock
service latches to support components when needed.
• Keep all parts in good condition and properly installed.
Fix damage immediately. Replace worn or broken parts.
Replace all worn or damaged safety and instruction decals.
• Check all hardware at frequent intervals to be sure the
equipment is in safe working condition.
Wear Appropriate Safety Equipment
• Always wear eye protection when operating the machine.
• Wear close fitting clothing and safety equipment
appropriate for the job.
• While operating this machine, always wear substantial
footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandals.
• Wear a protective hearing device such as earplugs.
Loud noise can cause impairment or loss of hearing.
6
Loading...