Terk FDTV2A User Manual

FDTV2A

Owner’s Manual

FDTV2A Flat Antenna
Amplified Indoor Television Antenna

FDTV2A

About Your TERK
FDTV2A Flat Antenna

Thank you for choosing the TERK FDTV2A. TERK
antennas are designed to deliver sharp, clear
reception of digital signals. At TERK, our engineering
department is dedicated to designing antennas that
enhance both the latest technology and the aesthetics
of any viewing environment. The FDTV2A installs
in minutes and is easy to use. The FDTV2A has a
patented design that lets it receive signals from
360-degrees and work in both the horizontal and
vertical planes, which means it requires virtually no
adjustments once you’ve put it in place.

Before using your antenna, please remove all parts
from the box and read this owner’s manual carefully.

The FDTV2A antenna package includes the following
items:

1 FDTV2A Antenna Pro with Built-In Coaxial Cable
1 Removable Stand
1 Power Adapter
1 Removable In-Line Amplifier with Built-In Coaxial

Cable

1

FDTV2A

Installing your FDTV2A
antenna

Find the best location for the Antenna

Before you connect the antenna, determine the best
spot in your home for optimum reception. Visit
www.antennaweb.org to see where your local
broadcasts are coming from. Then, try as much
as possible to avoid obstructions between these
transmitters and your antenna.

Positioning the Antenna

Once you’ve found the best place to set up your
antenna, you have three options for placing it—you
can lay it flat, hang it on the wall, or stand it upright.

The antenna is designed to perform equally well in all
three positions. For most settings, the recommended
position is standing. However, the best position for
your antenna may vary depending on your location
and setting. Television signal waves bounce off of
objects, causing signal reflections that might cause
the antenna to perform better in one location or
orientation over others. Test the antenna in the
different positions before putting it in its permanent
position.

2

Please Note: Do not place your FDTV2A near large

metal objects or appliances that could create
interference.

FDTV2A

Installation (continued)

Attaching the Stand

The provided stand attaches to the back of the FDTV2A
for standing the antenna upright.

To attach the FDTV2A stand:

1. Line the pegs on the stand with the slots on the
back of the antenna.

2. Insert the pegs in the slots and pull up to lock the
stand into place.

3