Teltonika UM1000, G10 User Manual

Address: Žirmūnų g. 27, Vilnius LT-09105, Tel.: +370 5 2127472, Fax: +3705 276 1380, E-mail: info@teltonika.lt
TELTONIKA
ModemUSB/G10 (UM1000)
User Manual v0.2
ModemUSB/G10 Users Manual
TABLE OF CONTENTS
TABLE OF CONTENTS................................................................................................................................2
1. ATTENTION........................................................................................................................................... 3
2. FOR YOUR SAFETY.............................................................................................................................3
3. USER‘S SERVICE ...................................................................................................................................5
4. BASIC INFORMATION ....................................................................................................................... 6
4.1 Introduction......................................................................................................................................6
4.2 Legal Notice...................................................................................................................................... 6
4.3 Contacts............................................................................................................................................. 6
4.4 Acronyms..........................................................................................................................................6
5. PACKAGE CONTENTS.......................................................................................................................7
6. TECHNICAL SPECIFICATION.........................................................................................................7
6.1 Data transferring ..............................................................................................................................7
6.2 Recommended PC Configuration and Operation System support..........................................7
6.3 Indication .......................................................................................................................................... 8
6.4 Operating Parameters...................................................................................................................... 8
6.5 Mechanical characteristics...............................................................................................................9
7 HOW TO START? ..................................................................................................................................9
7.1 Driver and Software Installation on Windows 2000 and Windows XP..................................9
7.2 Driver and Software Installation on Windows Vista................................................................11
7.3 Software description......................................................................................................................12
7.3.1 Modem Control Tool Preparation to Work..........................................................................12
7.3.2 Connecting to Internet .............................................................................................................13
7.3.3 Sending SMS ..............................................................................................................................15
7.3.4 Settings of ModemUSB/G10..................................................................................................17
7.4 Uninstalling ModemUSB/G10....................................................................................................20
8 TECHNICAL SUPPORT.....................................................................................................................21
9 ENDING.................................................................................................................................................21
ModemUSB/G10 Users Manual
1. ATTENTION
All wireless devices for data transferring are susceptible to interference, which could affect performance
Service personnel may install driver of this product. We strongly recommend read this user manual before start installation.
The device is not water-resistant. Keep it dry.
IMPORTANT NOTES!
It is mandatory to read the notes and manual carefully before starting to use the device.
2. FOR YOUR SAFETY
In this document you will be introduced how to use ModemUSB/G10 device safely. We suggest you to adhere to following recommendations to avoid any damage to person or property. You have to be familiar with the safety requirements before starting to use the device!
Modem USB/E10 is used for data transfer by GSM network. The modem is designed to be connected to a PC through USB connector. By connecting the modem to a PC it is possible to connect to the Internet using GSM data transfer channel. To avoid user injures that could be caused by heat or electrical voltage it is important to follow safety requirements listed below.
Installation and technical support of the device can be performed only by a service personnel or a person who has enough knowledge about this device and safety requirements.
The PC to which the ModemUSB/G10 device is to be connected must have a USB port confirming to USB 2.0 standards. Modem is supplied from +5V DC USB port.
The PC to which the device is connected shall comply with the requirements of standard EN 60950-1. ModemUSB/G10 modem can be used on first (Personal Computer) or second (Notebook) computer safety class.
To avoid mechanical damage of the device, it is recommended to transport the device
packed in damage-proof pack. While using the device, place it such that the LED is visible to the user. It’s because this LED provide information about the working modes and condition of the device.
Signal level of the modem depends on the environment in which it is working.
ModemUSB/G10 Users Manual
A
A
y
If the device fails to work properly, only qualified personnel may repair this product. We recommend to dismantle the device and forward it to repair centre or to the manufacturer. The modem does not contain any parts, which can be replaced.
At the installation site, supply circuits should have protective devices (bipolar back up
protection device) which will protect from short-circuit and wrong ground installation. The power of connected device should satisfy power of release device. The interstice between contacts should be
no less than 3mm.
C outlets
230 V
Bipolar back up
protection device
PE
Line
Neutral
Mains Suppl
230V AC 50Hz
ssociated PC
ModemUSB/G10
2.1.pic. Connection scheme of modem and PC.
To turn off the modem, unplug it from the USB port of the PC or unplugging the PC from the power supply.
ModemUSB/G10 Users Manual
ª The device should not be connected to PC before the installation of the drivers. ª SIM card is mandatory for setting up connection to the GSM network. However, the
manufacturer of this equipment does not supply the SIM card. The SIM card can be
purchased from your GSM (mobile) service provider!
ª For APN, user name and password please contact your GSM (mobile) service provider. ª The modem must be unplugged from the PC while inserting or taking out the SIM card. If
the SIM card will be inserted or taken out from the modem while it is still plugged to the PC
– it may cause damage to the modem or the SIM card. In this case, the modem will not be
replaced or repaired under guarantee.
ª The modem can be unplugged from the PC only if it is disconnected from the Internet and
the MTC is properly closed.
ª If the modem is unplugged properly from the PC wait for at least 10 seconds before plugging
it back to the PC. Otherwise restart your PC before inserting modem back.
3. USER‘S SERVICE
When the device is not working as per its technical specifications, the technical service of device can performed only by a qualified personnel. It is strongly recommended to handover the modem to repairer or manufacturer. No exchangeable parts inside of modem.
Do not mount or serve device during a thunderbolt.
ModemUSB/G10 Users Manual
4. BASIC INFORMATION
4.1 Introduction
ModemUSB/G10 is a device designed for data transmission via GSM Network. The user-
friendly design allows you to directly connect the device to one of the USB ports of your PC/laptops. Once a SIM card is inserted in the modem and the device is connected to the PC, you would be able to send SMS or access internet via GSM networks (mobile networks). ModemUSB/G10 supports the following data-bearers: CSD, GPRS and SMS.
4.2 Legal Notice
Copyright © 2007 TELTONIKA Ltd. All rights reserved. Reproduction, transfer,
distribution or storage of part or all of the contents in this document in any form without the prior written permission of TELTONIKA Ltd is prohibited.
Other product and company names mentioned herein may be trademarks or trade names of their respective owners.
4.3 Contacts
If you face any problems related to the device, which you are not able to solve by yourself,
please contact your local distributor. We will be very glad to help you.
4.4 Acronyms
APN Access Point Name.
CSD Circuit Switched Data.
GPRS General Packet Radio Service.
GSM Global System for Mobile communications.
ISP Internet Service Provider.
PIN Personal Identification Number.
SIM Subscriber Identity Module.
SMS Short Message Service.
TCP/IP Transmission Control Protocol/Internet Protocol.
USB Universal Serial Bus.
ModemUSB/G10 Users Manual
5. PACKAGE CONTENTS
ModemUSB/G10 modem is packed in a box and contains all the accessories required for normal operation:
ª ModemUSB/G10 modem. ª CD with User Manual and drivers. ª “USB A jack USB A socket“ connection cable. ª Leaflet “Quick Start Guide”.
Note: The manufacturer does not supply the SIM card, which is mandatory for setting up a connection to the GSM network! The SIM card may be purchased from your GSM (mobile) service provider!!
If any of the components are missing please contact your local distributor.
6. TECHNICAL SPECIFICATION
6.1 Data transferring
The data type and data transfer speed depends on the service provided by your GSM
operator. ModemUSB/G10 supports the following data-bearers.
ª 850/900/1800/1900 MHz. ª Capacity class 4 (2W) 850/900 MHz waves ª Capacity class 1 (1W) 1800/1900 MHz waves. ª GPRS class 10. ª GPRS CS1 – CS4. ª CSD (up to 9.6 kbps).
6.2 Recommended PC Configuration and Operation System support
ª CD – ROM. ª USB v 2.0 port. ª 100 MB of free hard disk space. ª Supported Operating Systems: Windows 2000 (SP4), XP (SP2) and Vista. ª Drivers available for Mac OS X, Linux kernel 2.4.32 or higher.
Loading...
+ 14 hidden pages