Teltonika G10 User Manual

ModemUSB/G10 (UM1000)

Quick Start V0.2

TELTONIKA

Thank you for purchasing our device! We hope this feature-packed, user-friendly device will
satisfy your expectations. Please take few minutes to read this Quick Start Guide before starting to
work with ModemUSB/G10. This would make the installation and use of the device easier.

Address: Žirmūnų g. 27, Vilnius LT-09105,
Tel.: [phone],
Fax: [phone], E-mail: [e-mail]

i i i

INTRODUCTION

This Quick Start Guide has been prepared for Windows XP (SP2) operating system. For
installation guide on other supported operating systems, please refer to User Guide provided on CD.

ModemUSB/G10 is a device designed for data transmission via GSM Network. The design of this
modem enables the connection to your PC through USB interface. Once connected to the PC, you can send
SMS or access the Internet via one of the data transmission types supported by your GSM operator.
ModemUSB/G10 supports the following data-bearers: GPRS, CSD and SMS.

1) ModemUSB/G10 device.

2) USB A plug Ù USB A jack cable.

3) CD (including drivers and appropriate documentations).

4) Quick Start Guide.

If any of the components are missing please contact your local distributor.

Before you begin make sure that:

CONTENTS OF YOUR PACKAGE

i

HOW TO BEGIN?

 You are using Windows XP operating system with SP2 installed and you personal

computer hardware meets minimal requirements of this operating system. For
installation guide on other supported operating systems, please refer to User Guide
available on CD.

 You have a GSM SIM card with activated data transfer service.
 ModemUSB/G10 is ready to work – SIM card is pushed in.
 Dial-up networking is installed on your PC (OS) (this should be installed with OS by

default).

 TCP/IP protocol is installed on your PC (it should be present in your OS by default).

INSTALLING THE MODEM CONTROL TOOL

Notice: Whenever the driver installation is going to be performed, the modem should be unplugged

Open the ModemUSB/G10 package, take out the CD and insert it into your CD drive. Click Install in
automatically opened window. If the window did not appear, run autorun.exe file located on the CD. The installation
procedure of the ModemUSB/G10 modem will begin.

from the PC!

Advanced User: Can press Browse button to
choose specific folder where you wish to install
Modem Control Tool.

1

1

1

22

2

33

3

2