Telsey Telecommunications FS100 series User Manual
Telsey Telecommunications
Copyright statement
This publication may not be reproduced as a whole or in part, any way whatsoever unless prior consent
has to be obtained from Telsey.
10/100Mbps ETHERNET SWITCH: FS124 and FS126
FCC warning
Telsey Telecommunications
Electrical Safety and Emission Compliance Statement
The equipment complies with the following product specifications :
RFI Emissions : EN55022 Class A, FCC 47, Part 15, Class A;
Immunity : EN 55024 ; IEC61000-3-3; IEC61000-4-2; IEC61000-4-3;
IEC61000-4-4; IEC61000-4-5; IEC61000-4-6; IEC61000-4-11;
Safety : UNI EN 60825-1; UNI EN 60825-2, Class 1
Telsey Telecommunications
Package Content : all models
Thank you for selecting and purchasing our product. Before you start installing the 10/100 Mbps Ethernet
Switch, check that the following items are in the package
• 10/100 Mbps switch
• User’s Manual
Telsey Telecommunications
Port Speed
The twisted pair ports are compliant with the 10Base-T and 100Base-TX standards and are capable of
either 10 Mbps or 100 Mbps operation. The ports are IEEE 802.3u auto-negotiation compliant so the
switch will set the port speed automatically by the switch after it determines the speed of the end-node
connected to the port. Auto-negotiation is designed to ensure that the port on the switch and the
end-node are at the highest possible common speed of the devices.
Telsey Telecommunications
MDI, while a twisted pair port on a switch or hubs is usually MDI-X. To connect two 10 Mbps or 100 Mbps
network devices together that have dissimilar port wiring configurations, such as an MDI to MDI-X, you
would use a straight-through twisted pair cable. To connect two networks devices that have the same
wiring configuration, such as MDI to MDI, you would use a crossover cable.
The Switch features automatic MDI/MDI-X. The RJ-45 port automatically determines the configurations
of the port on the device to which it is connected and then configures itself appropriately.
Telsey Telecommunications
Installation
As with any electronic device, you should place the equipment out of extreme temperatures, humidity,
or electromagnetic interference. Specifically, the site you select should meet the following requirements:
• If you are installing the Switch on a table, be sure that the table is level and secure;
• If you are wall mounting the Switch, select a location on the wall that is safe and easily
Telsey Telecommunications
• Use dedicated power circuits or power conditioners to supply reliable electrical power to the
device.
Installation on a desktop
• If you are installing the Switch on a table, be sure that the table is level and secure; attach the
four protective feet, if available, to the bottom on the unit. Do not attach the protective feet if
you are wall-mounting the switch.
Telsey Telecommunications
1. Make sure all the devices you will connect to the Switch are powered off.
2. Connect a Category 5 Ethernet network cable to one of the numbered ports on the Switch.
3. Connect the other end to a PC or other network devices.
4. Repeat steps 2 and 3 to connect additional devices.
5. Connect the supplied power adapter to the power port on the Switch’s back panel.
Note: Make sure you use the power adapter included with the Switch. Using a different
Telsey Telecommunications
1. FS105, FS108: 10/100MBPS ETHERNET SWITCH
Features
• 5 port 10/100Mbps TX Auto-Negotiation Ethernet Switch (FS 105)
• 8 port 10/100Mbps TX Auto-Negotiation Ethernet Switch (FS 108)
• Full/Half-Duplex capability on each TX port
• Supports TP interface Auto MDIX function for auto TX/RX swap
Loading...