Telldus TZWP-102 User Manual

1 (5)

User manual

Telldus Plug-in Switch Mini
Firmware version: v1.0
Type: TZWP-102
Item number: 315510

Z-Wave Plug-in Switch Mini. Control lighting and other electronic equipment up to 2300 W
(resistive load). The device is designed with very thin edges, making it possible to use two
devices side by side in most electical outlets. The device acts as a repeater for the Z-Wave
network.

Specification

Maximum load: 10A / 2300 W (resistive load)
Range: Up to 30 meters indoor
Operating temperature: -10 - 40°C
Power consumption: <1W
Frequency: 868.42 MHz (EU)

Brand name:

Terminology

Add The process of including a node into the Z-Wave network.
Remove The process of excluding a node from the Z-Wave network.

Installation

Insert the device into the electrical outlet where it’s supposed to operate. Make sure that the
product you are connecting does not draw more than 2300 Watts. Test that it’s possible to
control the device manually by pressing the button.

Add device

This device can be included and operated in any Z-Wave network with other Z-Wave
certified devices from other manufacturers and/or other applications. All non-battery
operated nodes within the network will act as repeaters regardless of vendor to increase
reliability of the network.

When the device is not added to any Z-Wave network, the LED will flash slowly.

If the device already is added to a Z-Wave network, follow the remove device process before
adding it to your network. Otherwise adding this device will fail.

Automatically add device to network

When the device is inserted into an electrical outlet it’s in automatical add mode (Network
Wide Inclusion, NWI). This means that the device is added automatically when the Z-Wave
controller enters add mode.

Telldus is marketed by Proove AB, Sweden
www.proove.se • [phone]

www.telldus.com

2 (5)

Manually add device to network

Start the add mode on the Z-Wave controller. Press the button on the device three times
fast. The device will now be added into the Z-Wave network.

Remove device

Start the exclusion mode on the Z-Wave controller. Press the button on the device three
times fast. The device will now be removed from the Z-Wave network.

Reset the device

Method 1

Remove the device from the Z-Wave network. This will reset the device to factory defaults.

Method 2:

Reset the device by:
Press and hold the button for 5 seconds.
The device will now reset to factory defaults. The LED will now flash slowly, indicating that
it’s no longer added in any Z-Wave network. This procedure is called ‘Device Reset Locally’
and it should only be used when the primary controller is missing or inoperable.

Operating the device

The plug-in switch can be operated by the button on the product or wireless through the

Z-Wave network. A click on the button toggles the switch on or off.

LED-indicator

Please note that the configuration parameter 4, ‘LED Indicator’ might has been set to ‘When
operating plug, the LED is lit for 5 seconds’, making the LED not light up all the time when
the plug status is on.

Not in network Flashing slowly
On Steady blue (depending on configuration 4, ‘LED Indicator’)
Off Off (depending on configuration 4, ‘LED Indicator’)
During interview Flashing fast

Associations

Association group 1 - Lifeline - Plug status - Max 5 nodes

The plug will send it's status to the node(s) in this group whenever the status of the plug
changes.
Lifeline is normally used to send the plug status to the main controller / gateway.





Telldus is marketed by Proove AB, Sweden
www.proove.se • [phone]

www.telldus.com