Telitek Wireless 1508 User Manual
e
GMS50T User Manual
www.tel em2m.com
Electrical
DC Power Input: 6-32V
Internal rechargeable Battery: 3.7V
Power Consumption: 70mA@12V average
400uA@3.7V sleep
Cell Modem
Quad Band: 850/900/1800/1900MHz
GPRS Multi-Slot Class 10/8
GPRS Mobile Station Class B
Compliant to GSM phase 2/2 F
-Class 4 (2W@850/900 MHz)
-Class 1 (1W@1800/1900MHz)
HSPA/UMTS: All Bands
HSPA data rate: 5.6Mbps upload
7.2Mbps download
HSPA Fall back: EDGE/GPRS/GSM Quad band
EDGE MCS1-MCS9
3GPD Release 6
GPS
SiRF Star IV chip solution
48 PRN Channels
Super Sensitivity: Tracking -163 dBm
Acquisition -148 dBm
Active Jammer remover
Self –Assisted CGEE
Accuracy <2.5m CEP
I/O
Internal Cell and GPS antennas
SIM internal Access
Two inputs and one output
One RS232 for 3 part device connections
rd
Environmental
Working Temperature: -30C° to 75C°
Storage Temperature: -40C° to 85C°
Humility: 95% RH @50C non condensing
Shock and Vibration: SAE J1455
Water Proof housing: IP67
Mechanical
Dimension: 158x74x25MM
Weight: 280g
Optional Accessories
External Iridium Modem
Trailer Cargo sensor
Trailer Door Sensor
Certifications
Fully Certified: FCC, IC, CE, PTCRB Carrier Approval
TELITEK WIRELESS INC. IS A TURN KEY TELEMATICS AND
M2M SOLUTIONS PROVIDER, CUSTOMERIZED HARDWARE,
FIRMWARE AND SOFTWARE DEVELOPMENT AVAILABLE AS
YOUR REQUEST.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user ’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of thefollowing measures:
¨Reorient or relocate t he receiving antenna.
¨Increase the separat ion between the equipmen t and recei ver.
¨Connect the equipmen t into an outlet on a circuit di fferent from that to whic h the recei ver is connected.
¨Consult the dealer or an e xperienced radio/ TV techni cian for help.
FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC’s RF exposure guidelines, place the
product at least 20cm from nearby persons.
Telitek Wirele ss In c.
1001 Denison S tre et Su ite 202 Markham Onta rio L 3R 2Z6 Canada
Toll Free: +1 877 33 3 638 6 Fax : +1 905 766 4544 Email: t eli tek@telem2m.co m
Loading...