Telikou WTI-100 Instruction Manual

TELIKOU Intercom System

WTI-100 Simplex wireless

Interface

Instruction Manual

© 2006 TELIKOU Systems

All Rights Reserved
www.telikou.com

While TELIKOU makes every attempt to maintain the accuracy of the information contained in
its product manuals, the information is subject to change without notice.

TELIKOU WTI-100 Simplex Wireless Main Station

1

I. Introduction

Thank you for choosing TELIKOU intercom product. The WTI-100 walkie talkie wireless
interface connects to wired intercom main station. Receive and transmit signal by simplex
model. WTI-100 is suitable for TV station, communication command center, outside
broadcast vehicle, theater, project test field, and other applications which communication
is required.

II. Equipments connection

1. Connect To 2-Wire System

By 2 core with shield audio cable. This 2-wire connector (18) is used to connect WTI-100
to any intercom channel of 2-wire main station. Set 2-wire/4-wire selection switcher
(switcher 11) to ―2-wire‖ position. Connector (18) is a pair of loop through XLR-3
connectors.
The pin definition is as follow:

Pin1 -- Common, Cable shield
Pin2 – Null
Pin3 – Audio;

2. Connect to 4-wire System

Connector (17) is a 4-wire equipment connector. When use this connector, the switcher at
front panel should be turned to ―4-Wire‖ position.
Connector (17) is a RJ-45 connector. Face rear panel, the pin definition (from right to left)
is as follow:

Pin1 – Audio, - input
Pin2 – Audio, + Output