Telguard TG-7 Series Quick Installation Manual

COMPANY CONFIDENTIAL
For use by TELGUARD

®

customers only.

Distribution to other parties strictly prohibited.

June 22, 2012 56044203

Telguard TG-7 Series
Quick Installation Guide

56044203

Telguard TG-7 Series

QUICK INSTALLATION GUIDE [BACKUP MODE]

Installation Summary

There are seven steps in installing Telguard properly. IF YOU DO NOT
PROCEED IN THE ORDER AND MANNER PRESCRIBED, YOU MAY
NOT COMPLETE THE INSTALLATION IN THE TIME ALLOCATED.

STEP 1: REGISTER FOR CELLULAR SERVICE

Register the unit online through www.telguardonline.com, by completing the
Online Registration Form at www.Telguard.com. Telular requires this
information to activate the unit.

STEP 2: LOCATE UNIT AND MEASURE SIGNAL STRENGTH (RSSI)

First, you will be confirming that Telguard has adequate cellular signal strength. Press the
LED/RSSI Mode Toggle button one time, LEDs will now indicate signal strength. Minimum
recommended is 2 ½ (2 on solid and the third flashing). Press the LED/RSSI Mode Toggle
button a second time to exit RSSI mode.

STEP 3: TRANSMIT PANEL ALARMS OVER THE TELCO CONNECTION

Next, you will verify that the alarm panel is programmed properly. This step is important to verify
that the alarm panel is programmed with valid account code and central station information
before transmitting signals through the cellular network.

STEP 4: PROGRAM, ACTIVATE & TRANSMIT PANEL ALARMS OVER THE
CELLULAR RADIO NETWORK

Next, you will be connecting the alarm panel's digital dialer output to Telguard and verifying that
alarm signals can be reliably sent through Telguard over cellular to the central station digital
receiver. The incoming Telco line is not

connected to Telguard during this step. A minimum of

two alarm signals must be transmitted. Activation is confirmed when LED 1 is illuminated.

(NOTE: THE FIRST ALARM WILL ACTIVATE THE UNIT AT THE TELULAR COMMUNICATION
CENTER, IT WILL NOT GO TO THE CENTRAL STATION, ALL SIGNALS AFTER THE FIRST ARE

SENT TO THE

CENTRAL STATION)

STEP 5: CONNECT SUPERVISORY TRIP OUTPUTS

Next, you will wire Telguard's supervisory trip outputs to the alarm panel and then test.

STEP 6: CONNECT TRIP INPUT (OPTIONAL)

Optionally, you can wire an external relay input to the trip input lead and ground, and test.

STEP 7: COMPLETE THE INSTALLATION

Your last step will be to attach earth ground, reconnect Telco, and permanently mount the unit.