TeleWell TW-EA510v3 (c) 3G, TW-EA510v3 (C) Quick Start Manual

TeleWell

TW-EA510v3 (c) 3G/4G

!!

!

ADSL!&!3G/4G!Modem!Router!

Firewall!WLAN!AP!(802.11!b/g/n)

Quick Start Guide

TeleWell TW-EA510v3 (c) ADSL 3G/4G Modem Router

1

Package Contents

TeleWell TW-EA510 ADSL 3G/4G Modem Router Firewall WLAN AP (802.11 b+g+n)

CD containing the on-line manual and QSG

RJ-11 ADSL/ telephone cable

Ethernet (RJ-45) cable

Two 2dBi detachable antennas

Power adapter 12V DC, minimum 1.2A

Quick Start Guide

Telephone plug (Micro-filter Optional)

Attention

Attention

Warning

PLEASE READ THE QUICK START GUIDE AND FOLLOW THE
STEPS CAREFULLY. THIS QUICK START GUIDE WILL HELP YOU
INSTALL THE DEVICE PROPERLY AND AVOID IMPROPER
USAGE. IF YOU NEED MORE INFORMATION ON THIS SOFTWARE
CONFIGURATION, PLEASE REFER TO THE USER MANUAL ON
CD-ROM.

! Do not use the router in high humidity or high temperatures.
! Do not use the same power source for the router as other

equipment.

! Do not open or repair the case yourself. If the router is too hot,

turn off the power immediately and have it repaired at a qualified
service center.

! Avoid using this product and all accessories outdoors.

! Place the router on a stable surface.
! Only use the power adapter that comes with the package. Using a

different voltage rating power adaptor may damage the router.

Quick Start Guide

2

Hardware Overview

Hardware Overview

The Front LEDs

The Rear Ports

* Note 1. For advanced reset and restore setting, please refer to user manual.

.2. For WPS configuration, please refer to the WPS section of user manual.

Connect with the
supplied power
adapter.

Connect the supplied
RJ-11 cable to this
port when connecting
to the ADSL/
telephone network.

(1)

WPS

WPS: Press 2-6 seconds until WPS LED

flashes green to trigger WPS function.

*2

(2)

Wireless ON/OFF Switch

Wireless ON/OFF Switch: Press over 6

seconds after WPS LED is off to switch on
wireless function. Press over 6 seconds
again to disable wireless function.

Flash green when
WPS configuration
is in progress.

Lit red when WAN port
fails to get IP address.
Lit green when WAN
port gets IP address
successfully.

Connect your
computer to a
LAN port with
the Ethernet
cable included.

Power
ON/OFF
switch

Blink green when power is
on and system is booting.
Lit green when the system
is ready. Lit Red if the
system is dead.

Lit green when a wireless
connection is established.
Blink when data is being
sent / received.

Lit green when the device
is successfully connected
to an ADSL DSLAM. (“Line
sync”).

When the device
power is on,
press to reset or
to restore its
factory default
setting. *1

Antenna

Lit when USB device
is connected to the
router.

Connect the USB
cable to this port.

Lit when connected to an
Ethernet device. Lit green when
the speed of transmission hits
10/100Mbps; Blink when data is
being Transmitted / Received.