Tele Vue Mount Handle User Manual

Page 1
MOUNT HANDLE INSTRUCTIONS
Parts List:Parts List:
Parts List:
Parts List:Parts List:
1) Foam covered Mount Handle
2) Handle Attachment Block
3) Parts Bag including: 2 #10-32 button head screws 1 Allen (Hex) Key
IntroductionIntroduction
IntroductionIntroduction
Thank you for purchasing the Mount Handle for the Tele Vue Tele-
Pod and Panoramic Mount. Adding the handle to the bottom of the cradle will give you more control over the movement in both axes.
Installation:Installation:
Installation:Installation:
If you have a Tele-Pod or Panoramic Mount head that has a cradle base pre-drilled to accept the mount handle assembly:
1) Hold the Handle Attachment Block under the left or right side
(whichever you prefer) of the cradle base and line up with holes.
2) Thread in the button head screws and tighten with the supplied Allen
Key.
If your Tele-Pod or Panoramic Mount head is NOT pre-drilled for the Mount Handle:
1) Using the supplied template as a guide, set your head up on a drill
press and drill 3/16" diameter clearence holes in either or both sides of the cradle base.
2) Hold the Handle Attachment Block under the left or right side
(whichever you prefer) of the cradle base and line up with holes.
3) Thread in the button head screws and tighten with the supplied Allen
Key.
Parts Bag Contents Mount
Handle Attachment Block
Mount Handle
Foam Covered Grip
Removal:Removal:
Removal:
Removal:Removal:
For storage, you may unscrew the foam covered handle from the adapter block.
Button
Mount Handle attached to Tele-Pod
Head screws
Cradle Base
Mount Handle Attachment Block
Te l e Vu e
Visionary
32 Elkay Dr., Chester, New York 10918 (845) 469-4551 www.televue.com
Page 2
MOUNT HANDLE DRILLING TEMPLATE
3/16" Clearance holes for #10-32 screws (4)
5/8"
This side toward focuser end of telescope
1-3/16"
1-1/16"
9/16"
Cradle Base
Te l e Vu e
Visionary
32 Elkay Dr., Chester, New York 10918 (845) 469-4551 www.televue.com
Loading...