Teleste EOC04 Install And Operation Instructions
Install and applications guide
What’s in the box 2
Product overview 3
Connectivity 4
Set up options 5
Wi-Fi & Ethernet extension using existing Cable TV wiring 6
Wi-Fi & Ethernet extension using existing DVB -T (TV aerial) cabling 7
Setup and Configuration procedure Cable TV wiring 8
Wi-Fi SSID and Password Setup 9
How to change the IP address of an EOC-04 11
SUPER USER menu 19
Sections
EOC04 Ethernet over
Coax Wi-Fi extender
Setup and applications guide
1 x EOC04 Wi-Fi Extender
2 x Wi-Fi aerials
1 x PSU
1 x Ethernet Patch cord
1 x Coax fly lead
1 x F to IEC adapter
1 x Quick start Guide
What’s in the box?
2
Wi-Fi Aerials
Reset button WPS indicator Local Ethernet Connection
Green = Gigabit Connection
Red = 100 Base-T connection
WiFi Status
(Flashing green = active)
WPS connect Power (Red = on) Ethernet over coax Connection
(Yellow = connected)
Product overview
Wi-Fi Aerial
Connector
12 Volt
power
4x Gigabit Ethernet Ports TV / CATV + Ethernet
over Coax Signal INPUT
TV ONLY OUTPUT
to TV or Set top Box
(does not carry Ethernet signal)
3
Connectivity
Attach Wi-Fi
antennas here
Ethernet connection
To Smart TV or IP Device
Loop out connection
Goes to TV or Set top
box RF IN connector
Connect from RF Wall outlet to
Cable in connector on EOC-04
Attach Wi-Fi
antennas here
4
Set up options
The EOC04 is a multi-purpose Ethernet over coax bridge device. It can be used in
a number of dierent ways to deliver Gigabit Ethernet and 2 Channel Wi-Fi via a
Coax ( TV aerial or Cable TV) connection.
It can be used as either a sender or receiver but will need to be used with at least
one other Ethernet over Coax or MoCA compatible device. This can be either…
A Maximum of 16 EOC devices can be used in any in home network
Each being able to send and receive Gigabit Ethernet via the existing TV aerial or
Cable TV cabling structure that is already installed in the home
The following pages show the most common configurations…
Another EOC04
An EOC03
5
Wi-Fi & Ethernet extension using
existing Cable TV wiring.
Coax Cable
Main CATV feed
into Home
Ethernet
The first EOC adapter needs to be connected to the Cable Modem, Via an
Ethernet patch cord, to get an Ethernet signal into the system.
A connection from a spare OUTPUT on the CATV distribution amplifier to the
CABLE IN connection on the EOC adapter. It is essential that the first EOC adapter
is only connected to an OUTPUT port of the amplifier, as the Ethernet over coax
signal cannot pass through the amplifier.
At the EOC04 Wi-Fi extender, connect the ‘CABLE IN’ socket to the wall outlet.
Use the supplied COAX fly lead to then remake the connection to the TV or set
top box, so that the signal is passing through the EOC04.
Connect any Ethernet devices – Smart TV, IP Set top Box etc. using an Ethernet
patch cord.
Power up the EOC device – the unit will take between 10-15 seconds to boot up
and stabilise.
See section 8 - ‘Set up and configuration’ for more details.
EOC04 WiFi
Extender
SMART TV With Ethernet
Connection from EOC04
EOC04 WiFi
Extender
Set top box with Ethernet
connection from EOC04
First EOC adapter
Gateway Router
Distribution
amplifer
6
Loading...