Telematics Wireless XMETER3 Updated Installation Manual

Note:

r has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference will

ar installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

Draft

User Manual

TMW-40D

TMW-40D FCC ID: NTAXMETER3

Manufacturer: Tadiran-Telematics Ltd.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,

including interference that may cause undesired operation.

The digital portion of the transceive

protection against harmful interference in a residential installation. This equipment

not occur in a particul

correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Consult the dealer or an experienced radio/TV technician for help.

Draft

Installation

Following information will be included in the User Manual

- The user and the installer should be aware that changes and modifications not
expressly approved by Tadiran Telematics could void the user’s authority to
operate the equipment.

- This equipment shall be installed by professional personnel. The equipment
shall be installed at the bottom of the water meter pit as described in the
following picture:

-

The unit is installed as shown in the center of the bottom of the pit.