Telematics Wireless XMETER10 Users Manual

Draft

User Manual

LC-TMW

Note:

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:

1) This de vice ma y not cause harmful interference, and

2) This device must accept any interference received, including interference that may cause
undesired operation.

The digital portion of t he transceiver has been tested and found t o comply with the lim its for a Class B
digital device, pursuant to p art 15 of the FCC Rules. These limit s are designed to provide reasonable
protection against harmful interference in a residential installation. This equipme nt generates, uses and
can radiate radio frequency ener gy and, if not installe d and u sed in accor dance wit h the ins tr ucti ons, may
cause harmful interference to radio communications. Howeve r, t here is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or m ore of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to whic h t he recei ver is connect ed.

-Consult the dealer or an experienced radio/T V tech nic i an for help.

Draft

Installation

Here we shall add the installation Instruction which shall include the following
statements:

The user and the installer should be aware that changes and modifications not
expressly approved by Telematics Wireless could void the user’s authority to operate
the equipment.

NOTE: The antenna used for this transmitter must be installed to normally provide
minimum separation distance of at least 20 cm from all persons and must not be
co-located or operating in conjunction with any other antenna or transmitter.

The LC-TMW transmission duty cycle is limited by its design not to exceed 0.12%.