Telematics Wireless T210 User Manual

Tnet 210 Module

Installation

Instructions

FCCID:NTAT210



January13,2013

Rev1.0

PROPRIETARY INFORMATION

ALL RIGHTS RESERVD, NO PARTS OF THIS DOCUMENT MAY BE REPRODUCED,

STORD IN RETRIEVAL SYSTEM, OR TRANSMITTED IN ANY FORM OR BY ANY

MEANS, ELECTRONIC, MECHANICAL PHOTOCOPYING, RECORDING OR

OTHERWISE WITHOUT THE PRIOR WRITTEN PERMISSION OF TELEMATICS

WIRELESS LTD. NOR USED IN WHOLE OR IN PART FOR ANY PURPOSE OR FOR

ANY CUSTOMER EXCEPT TELEMATICS WIRELESS.

Tnet 210 Installation Instructions Rev 1. 0 January 13, 2013 Page 1 of 3

CAUTION

The User and the Installer should be aware that changes and modifications to the equipment not
expressly approved by Telematics Wireless could void warranty and the user's authority to
operate the equipment.

Professionally trained personnel should install the equipment.

The antenna used for this transmitter must be installed to normally provide minimum separation
distance of at least 20 cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter

ATTENTION

The digital portion of the transceiver has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.

This device complies with Part 15 of FCC Rules. Operation is subject to the following two
conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may cause
undesired operation.

Tnet 210 Installation Instructions Rev 1. 0 January 13, 2013 Page 2 of 3